[PATCH v2 5/9] fdt: Correct condition for bloblist existing

[Simon Glass <sjg@chromium.org>]

On some boards, the bloblist is created in SPL once SDRAM is ready. It
cannot be accessed until that point, so is not available early in SPL.

Add a condition to avoid a hang in this case.

This fixes a hang in chromebook_coral

Fixes: 70fe2385943 ("fdt: Allow the devicetree to come from a bloblist")

Signed-off-by: Simon Glass <sjg@chromium.org>
---

Changes in v2:
- Use 'phase' instead of 'stage'

 lib/fdtdec.c | 12 ++++++++++--
 1 file changed, 10 insertions(+), 2 deletions(-)

diff --git a/lib/fdtdec.c b/lib/fdtdec.c
index b2c59ab3818..79eaa56ea39 100644
--- a/lib/fdtdec.c
+++ b/lib/fdtdec.c
@@ -1669,8 +1669,16 @@ int fdtdec_setup(void)
 {
 	int ret = -ENOENT;
 
-	/* If allowing a bloblist, check that first */
-	if (CONFIG_IS_ENABLED(BLOBLIST)) {
+	/*
+	 * If allowing a bloblist, check that first. This would be better
+	 * handled with an OF_BLOBLIST Kconfig, but that caused far too much
+	 * argument, so add a hack here, used e.g. by chromebook_coral
+	 * The necessary test is whether the previous phase passed a bloblist,
+	 * not whether this phase creates one.
+	 */
+	if (CONFIG_IS_ENABLED(OF_BLOBLIST) &&
+	    (spl_prev_phase() != PHASE_TPL ||
+	     !IS_ENABLED(CONFIG_TPL_BLOBLIST))) {
 		ret = bloblist_maybe_init();
 		if (!ret) {
 			gd->fdt_blob = bloblist_find(BLOBLISTT_CONTROL_FDT, 0);
-- 
2.34.1