[PATCH v3 02/18] arm64: dts: rockchip: enable second PCIe controller on the Qnap-TS433

[Heiko Stuebner <heiko@sntech.de>]

The TS433 uses both pcie controllers for sata and the 2nd network
interface. Set the needed data-lanes in the pcie3 phy and enable
the second pcie controller, as well as remove the bifurcation comment.

Tested-by: Uwe Kleine-König <ukleinek@debian.org>
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
Link: https://lore.kernel.org/r/20240723195538.1133436-3-heiko@sntech.de

[ upstream commit: 0f5f87a1d602a33028522784eb005647fa1b5c11 ]

(cherry picked from commit 7d8f260e65cc84076ec9456954de0f136948a2c8)
---
 dts/upstream/src/arm64/rockchip/rk3568-qnap-ts433.dts | 10 +++++++++-
 1 file changed, 9 insertions(+), 1 deletion(-)

diff --git a/dts/upstream/src/arm64/rockchip/rk3568-qnap-ts433.dts b/dts/upstream/src/arm64/rockchip/rk3568-qnap-ts433.dts
index 07b4f095d76..9bf9c3b65ca 100644
--- a/dts/upstream/src/arm64/rockchip/rk3568-qnap-ts433.dts
+++ b/dts/upstream/src/arm64/rockchip/rk3568-qnap-ts433.dts
@@ -78,17 +78,25 @@
 };
 
 &pcie30phy {
+	data-lanes = <1 2>;
 	status = "okay";
 };
 
 /* Connected to a JMicron AHCI SATA controller */
 &pcie3x1 {
-	/* The downstream dts has: rockchip,bifurcation, XXX: find out what this is about */
 	reset-gpios = <&gpio0 RK_PC7 GPIO_ACTIVE_HIGH>;
 	vpcie3v3-supply = <&vcc3v3_pcie>;
 	status = "okay";
 };
 
+/* Connected to the 2.5G NIC for the upper network jack */
+&pcie3x2 {
+	num-lanes = <1>;
+	reset-gpios = <&gpio2 RK_PD6 GPIO_ACTIVE_HIGH>;
+	vpcie3v3-supply = <&vcc3v3_pcie>;
+	status = "okay";
+};
+
 &sdhci {
 	bus-width = <8>;
 	max-frequency = <200000000>;
-- 
2.45.2