[U-Boot] is uImage.FIT supported in U-boot 2008.10

[U-Boot] is uImage.FIT supported in U-boot 2008.10

[Pieter]

I am unable to find the mkimage tool that takes the -f vmlinux.bin.gz
argument. I am using ELDK4.2 compiling U-Boot 2008.10 using ARCH=powerpc
for a MPC8548 board.

is the uImage.FIT currently supported, if so, where can i find the tools
mentions in  /u-boot/doc/uImage.FIT/howto.txt

thanks pieter

[U-Boot] is uImage.FIT supported in U-boot 2008.10

[Wolfgang Denk]

Dear Pieter,

In message <497DCCFA.3070106@vastech.co.za> you wrote:
> I am unable to find the mkimage tool that takes the -f vmlinux.bin.gz
> argument. I am using ELDK4.2 compiling U-Boot 2008.10 using ARCH=powerpc
> for a MPC8548 board.

What about tools/mkimage ?

> is the uImage.FIT currently supported, if so, where can i find the tools
> mentions in  /u-boot/doc/uImage.FIT/howto.txt

As far as U-Boot is concerned, you can find the tools in the tools/
directory. This, um, sounds pretty obvious to me. Or not?

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
:       I've tried (in vi) "g/[a-z]\n[a-z]/s//_/"...but that doesn't
: cut it.  Any ideas?  (I take it that it may be a two-pass sort of solution).
In the first pass, install perl. :-) Larry Wall <6849@jpl-devvax.JPL.NASA.GOV>