[U-Boot] current ARM development head

[U-Boot] current ARM development head

[Alexander Stein]

Hello,

I noticed that there is a lot of changes in ARM part of u-boot. Especially the 
new relocation is a bit tricky. So I'm wondering what and where is the current 
ARM development head, especially the at91 part. Is it u-boot master branch or 
some other repository/branch?

Best regards,
Alexander

[U-Boot] current ARM development head

[Wolfgang Denk]

Dear Alexander Stein,

In message <201010270907.54241.alexander.stein@systec-electronic.com> you wrote:
> 
> I noticed that there is a lot of changes in ARM part of u-boot. Especially the 
> new relocation is a bit tricky. So I'm wondering what and where is the current 
> ARM development head, especially the at91 part. Is it u-boot master branch or 
> some other repository/branch?

Unless you are looking for some new and special feature (which you
understand well and where you are sure you really want and need it)
you should always refer to the "master" branch (or "next" if it
exists, i. e. after -rc1 is out and before the new merge window is
open) in the git://git.denx.de/u-boot.git repository.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
He had quite a powerful intellect, but it  was  as  powerful  like  a
locomotive,  and  ran on rails and was therefore almost impossible to
steer.                          - Terry Pratchett, _Lords and Ladies_

[U-Boot] current ARM development head

[Reinhard Meyer]

Dear Alexander Stein,

> I noticed that there is a lot of changes in ARM part of u-boot. Especially the 
> new relocation is a bit tricky. So I'm wondering what and where is the current 
> ARM development head, especially the at91 part. Is it u-boot master branch or 
> some other repository/branch?

As Wolfgang pointed out u-boot/master is where to look at.

u-boot-atmel/at91 might be a bit ahead (or back since I don't pull from
u-boot/master every day); but new things for at91 might be found there for a few days
until the are merged into master.

u-boot-atmel/wip (top9000 support) is probably the only working AT91SAM9 port based on
current TOT. Note that this is not official, it has not been reviewed by anyone and I
just have it there as a reference until all new things have settled down a bit. Then I
will officially make it a patch.

Best Regards,
Reinhard