[PATCH V2] mkimage: fit: Do not tail-pad fitImage with external data

[Marek Vasut <marex@denx.de>]

On 5/5/20 3:22 PM, Alex Kiernan wrote:
> On Mon, May 4, 2020 at 12:28 PM Tom Rini <trini@konsulko.com> wrote:
>>
>> On Fri, May 01, 2020 at 05:40:25PM +0200, Marek Vasut wrote:
>>
>>> There is no reason to tail-pad fitImage with external data to 4-bytes,
>>> while fitImage without external data does not have any such padding and
>>> is often unaligned. DT spec also does not mandate any such padding.
>>>
>>> Moreover, the tail-pad fills the last few bytes with uninitialized data,
>>> which could lead to a potential information leak.
>>>
>>> $ echo -n xy > /tmp/data ; \
>>>       ./tools/mkimage -E -f auto -d /tmp/data /tmp/fitImage ; \
>>>       hexdump -vC /tmp/fitImage | tail -n 3
>>>
>>> before:
>>> 00000260  61 2d 6f 66 66 73 65 74  00 64 61 74 61 2d 73 69  |a-offset.data-si|
>>> 00000270  7a 65 00 00 78 79 64 64                           |ze..xydd|
>>>                    ^^       ^^ ^^
>>> after:
>>> 00000260  61 2d 6f 66 66 73 65 74  00 64 61 74 61 2d 73 69  |a-offset.data-si|
>>> 00000270  7a 65 00 78 79                                    |ze.xy|
>>>
>>> Signed-off-by: Marek Vasut <marex@denx.de>
>>> Reviewed-by: Simon Glass <sjg@chromium.org>
>>> Cc: Heinrich Schuchardt <xypron.glpk@gmx.de>
>>> Cc: Tom Rini <trini@konsulko.com>
>>
>> Applied to u-boot/master, thanks!
>>
> 
> This breaks booting on my board (am3352, eMMC boot, FIT u-boot,
> CONFIG_SPL_LOAD_FIT). Not got any useful diagnostics - if I boot it
> from eMMC I get nothing at all on the console, if I boot over ymodem
> it stalls at 420k, before continuing to 460k. My guess is there's some
> error going to the console at the 420k mark, but obviously it's lost
> in the ymodem... I have two DTBs in the FIT image, 420k would about
> align to the point between them.

My bet would be on some padding / unaligned access problem that this
patch uncovered. Can you take a look ?