Re: [PATCH 0/7][RFC] function graph tracer port to PowerPC

[Michael Ellerman <michael@ellerman.id.au>]

[-- Attachment #1: Type: text/plain, Size: 1321 bytes --]

On Wed, 2009-02-11 at 20:10 -0500, Steven Rostedt wrote:
> The following set of patches are RFC and not for inclusion
> (unless everyone is fine with them as is).
> 
> This is the port to PowerPC of the function graph tracer that was written
> by Frederic Weisbecker for the x86 architecture.  It is broken up
> into a series of logical steps.
> 
> 1) get generic code ready for other archs
> 2) get PowerPC 64-bit working with just static function tracing
> 3) get PowerPC 64-bit working with dynamic function tracing
> 4) get PowerPC 32-bit working with just static function tracing
> 5) get PowerPC 32-bit working with dynamic function tracing
> 
> (with some clean ups in between)
> 
> 
> The function graph tracer not only traces the start of a function
> (uses the function tracer part for that) but also uses the kprobes
> trick to replace the return address with a hook to trace the exit
> of the function.

You use the "kprobes trick", but none of the kprobes code (AFAICS).
Couldn't there be some common code between the two?

cheers

-- 
Michael Ellerman
OzLabs, IBM Australia Development Lab

wwweb: http://michael.ellerman.id.au
phone: +61 2 6212 1183 (tie line 70 21183)

We do not inherit the earth from our ancestors,
we borrow it from our children. - S.M.A.R.T Person

[-- Attachment #2: This is a digitally signed message part --]
[-- Type: application/pgp-signature, Size: 197 bytes --]