Re: [PATCH 0/7][RFC] function graph tracer port to PowerPC

[Frederic Weisbecker <fweisbec@gmail.com>]

On Wed, Feb 11, 2009 at 09:16:57PM -0500, Steven Rostedt wrote:
> 
> On Thu, 12 Feb 2009, Frederic Weisbecker wrote:
> 
> > On Wed, Feb 11, 2009 at 08:10:51PM -0500, Steven Rostedt wrote:
> > > 
> > > The following set of patches are RFC and not for inclusion
> > > (unless everyone is fine with them as is).
> > > 
> > > This is the port to PowerPC of the function graph tracer that was written
> > > by Frederic Weisbecker for the x86 architecture.  It is broken up
> > > into a series of logical steps.
> > > 
> > > 1) get generic code ready for other archs
> > > 2) get PowerPC 64-bit working with just static function tracing
> > > 3) get PowerPC 64-bit working with dynamic function tracing
> > > 4) get PowerPC 32-bit working with just static function tracing
> > > 5) get PowerPC 32-bit working with dynamic function tracing
> > > 
> > > (with some clean ups in between)
> > > 
> > 
> > 
> > Thanks a lot Steven!
> > I'm sad to not having a Power Pc to test it...
> 
> If you had a PowerPC, I doubt I would have been the one to port it ;-)


Especially since you already implemented ftrace on PowerPc :)
I will acquire an Arm board soon to adapt function graph on Arm...
 
> -- Steve
>