[ath9k-devel] Setting master mode

[John Murphy <john.murphy@mandac.ie>]

Hi,

I am new to this list so apologies in advance for asking a question that
may have been answered before.

I am trying to setup a Jaunty box as an AP with a card in master mode. I
downloaded kernel 2.6.31, enabled mac80211 then rebuilt and installed
the new kernel. I have tried two different PCI cards, one based in the
Realteck chipset RTL-8185 and the other based on the Atheros AR5007G.
The problem is that I cannot set either card to Master mode. I have am
using compat-wireless-2.6.31-rc7 and kernel 2.6.31-2.6.31. Any help,
suggestions or valium would be most welcome right now.

John 

-- 
John Murphy
Technical And Managing Director
MANDAC Ltd
Kandoy House
2 Fairview Strand
Dublin 3
p: +353 1 5143001
m: +353 85 711 6844
e: john.murphy at mandac.ie
w: www.mandac.ie

Company Number:445600
VAT Number: IE9687362A
***********************************
This email contains information which may be confidential or 
privileged. The information is intended solely for the use of the
individual or entity named above. If you are not the intended
recipient, be aware that any disclosure, copying, distribution
or use of the contents of this information is prohibited. If you
have received this electronic transmission in error, please notify
the sender by telephone or by electronic mail immediately. Any opinions
expressed are those of the author, not Mandac Ltd. You are requested
to carry out your own virus check before opening any attachment as 
Mandac Ltd accepts no liability for any loss or damage which may be
caused by malicious software or attachments.