[PATCH 08/28] Blackfin SPI: fix up some unused/misleading comments

[Mike Frysinger <vapier-aBrp7R+bbdUdnm+yROfE0A@public.gmane.org>]

Reported-by: David Brownell <dbrownell-Rn4VEauK+AKRv+LV9MX5uipxlwaOVQ5f@public.gmane.org>
Signed-off-by: Mike Frysinger <vapier-aBrp7R+bbdUdnm+yROfE0A@public.gmane.org>
---
 drivers/spi/spi_bfin5xx.c |    8 ++------
 1 files changed, 2 insertions(+), 6 deletions(-)

diff --git a/drivers/spi/spi_bfin5xx.c b/drivers/spi/spi_bfin5xx.c
index 5e07f49..045c82a 100644
--- a/drivers/spi/spi_bfin5xx.c
+++ b/drivers/spi/spi_bfin5xx.c
@@ -44,9 +44,6 @@ MODULE_LICENSE("GPL");
 #define QUEUE_RUNNING	0
 #define QUEUE_STOPPED	1
 
-/* Value to send if no TX value is supplied */
-#define SPI_IDLE_TXVAL 0x0000
-
 struct driver_data {
 	/* Driver model hookup */
 	struct platform_device *pdev;
@@ -581,7 +578,7 @@ static void bfin_spi_pump_transfers(unsigned long data)
 			udelay(previous->delay_usecs);
 	}
 
-	/* Setup the transfer state based on the type of transfer */
+	/* Flush any existing transfers that may be sitting in the hardware */
 	if (bfin_spi_flush(drv_data) == 0) {
 		dev_err(&drv_data->pdev->dev, "pump_transfers: flush failed\n");
 		message->status = -EIO;
@@ -661,7 +658,6 @@ static void bfin_spi_pump_transfers(unsigned long data)
 		"transfer: drv_data->write is %p, chip->write is %p\n",
 		drv_data->write, chip->write);
 
-	/* speed and width has been set on per message */
 	message->state = RUNNING_STATE;
 	dma_config = 0;
 
@@ -966,7 +962,7 @@ static u16 ssel[][MAX_SPI_SSEL] = {
 	P_SPI2_SSEL6, P_SPI2_SSEL7},
 };
 
-/* first setup for new devices */
+/* setup for devices (may be called multiple times -- not just first setup) */
 static int bfin_spi_setup(struct spi_device *spi)
 {
 	struct bfin5xx_spi_chip *chip_info;
-- 
1.7.3.1