From: Joonas Lahtinen <joonas.lahtinen@linux.intel.com>
To: Imre Deak <imre.deak@intel.com>, intel-gfx@lists.freedesktop.org
Subject: Re: [PATCH 01/10] drm/i915: clarify comment about mandatory RPM put/get during driver load/unload
Date: Wed, 16 Dec 2015 12:44:27 +0200 [thread overview]
Message-ID: <1450262667.4707.9.camel@linux.intel.com> (raw)
In-Reply-To: <1450203038-5150-2-git-send-email-imre.deak@intel.com>
Hi,
On ti, 2015-12-15 at 20:10 +0200, Imre Deak wrote:
> Signed-off-by: Imre Deak <imre.deak@intel.com>
Reviewed-by: Joonas Lahtinen <joonas.lahtinen@linux.intel.com>
> ---
> drivers/gpu/drm/i915/intel_runtime_pm.c | 15 +++++++++++++--
> 1 file changed, 13 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/gpu/drm/i915/intel_runtime_pm.c
> b/drivers/gpu/drm/i915/intel_runtime_pm.c
> index 2c2151f..9945040 100644
> --- a/drivers/gpu/drm/i915/intel_runtime_pm.c
> +++ b/drivers/gpu/drm/i915/intel_runtime_pm.c
> @@ -1975,9 +1975,15 @@ int intel_power_domains_init(struct
> drm_i915_private *dev_priv)
> */
> void intel_power_domains_fini(struct drm_i915_private *dev_priv)
> {
> - /* The i915.ko module is still not prepared to be loaded
> when
> + /*
> + * The i915.ko module is still not prepared to be loaded
> when
> * the power well is not enabled, so just enable it in case
> - * we're going to unload/reload. */
> + * we're going to unload/reload.
+ * The following also reacquires the RPM reference the core
> passed
> + * to the driver during loading, which is dropped in
> + * intel_runtime_pm_enable(). We have to hand back the
> control of the
> + * device to the core with this reference held.
> + */
> intel_display_set_init_power(dev_priv, true);
>
> /* Remove the refcount we took to keep power well support
> disabled. */
> @@ -2313,6 +2319,11 @@ void intel_runtime_pm_enable(struct
> drm_i915_private *dev_priv)
> pm_runtime_mark_last_busy(device);
> pm_runtime_use_autosuspend(device);
>
> + /*
> + * The core calls the driver load handler with an RPM
> reference held.
> + * We drop that here and will reacquire it during unloading
> in
> + * intel_power_domains_fini().
> + */
> pm_runtime_put_autosuspend(device);
> }
>
--
Joonas Lahtinen
Open Source Technology Center
Intel Corporation
_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
http://lists.freedesktop.org/mailman/listinfo/intel-gfx
next prev parent reply other threads:[~2015-12-16 10:44 UTC|newest]
Thread overview: 44+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-12-15 18:10 [PATCH v4 00/10] drm/i915: improve the RPM device suspended assert Imre Deak
2015-12-15 18:10 ` [PATCH 01/10] drm/i915: clarify comment about mandatory RPM put/get during driver load/unload Imre Deak
2015-12-16 10:44 ` Joonas Lahtinen [this message]
2015-12-15 18:10 ` [PATCH 02/10] drm/i915: disable power well support on platforms without runtime PM support Imre Deak
2015-12-15 20:57 ` Ville Syrjälä
2015-12-15 22:55 ` Imre Deak
2015-12-16 11:12 ` Daniel Vetter
2015-12-16 13:21 ` Imre Deak
2015-12-16 17:31 ` Ville Syrjälä
2015-12-16 18:13 ` Imre Deak
2015-12-15 18:10 ` [PATCH 03/10] drm/i915: refactor RPM disabling due to RC6 being disabled Imre Deak
2015-12-16 10:54 ` Joonas Lahtinen
2015-12-16 11:01 ` Joonas Lahtinen
2015-12-15 18:10 ` [PATCH 04/10] drm/i915: remove HAS_RUNTIME_PM check from RPM get/put/assert helpers Imre Deak
2015-12-16 10:56 ` Joonas Lahtinen
2015-12-16 13:49 ` [PATCH 4.1/10] drm/i915: get a permanent RPM reference on platforms w/o RPM support Imre Deak
2015-12-16 13:53 ` [PATCH v2 " Imre Deak
2015-12-16 17:26 ` Ville Syrjälä
2015-12-16 18:22 ` Imre Deak
2015-12-17 11:44 ` [PATCH v3.1/10] " Imre Deak
2015-12-17 11:48 ` [PATCH v5 04/10] drm/i915: remove HAS_RUNTIME_PM check from RPM get/put/assert helpers Imre Deak
2015-12-17 12:46 ` Joonas Lahtinen
2015-12-15 18:10 ` [PATCH 05/10] drm/i915: add assert_rpm_wakelock_held helper Imre Deak
2015-12-16 12:11 ` Chris Wilson
2015-12-16 12:54 ` Imre Deak
2015-12-16 13:02 ` Chris Wilson
2015-12-16 13:39 ` Joonas Lahtinen
2015-12-16 13:43 ` Imre Deak
2015-12-15 18:10 ` [PATCH 06/10] drm/i915: use assert_rpm_wakelock_held instead of opencoding it Imre Deak
2015-12-15 18:10 ` [PATCH 07/10] drm/i915: add support for checking if we hold an RPM reference Imre Deak
2015-12-15 21:07 ` Chris Wilson
2015-12-15 22:52 ` Imre Deak
2015-12-16 0:14 ` Chris Wilson
2015-12-16 0:52 ` [PATCH v5 " Imre Deak
2015-12-15 18:10 ` [PATCH 08/10] drm/i915: check that we hold an RPM wakelock ref before we put it Imre Deak
2015-12-16 11:00 ` Joonas Lahtinen
2015-12-16 11:07 ` Chris Wilson
2015-12-16 12:49 ` Imre Deak
2015-12-15 18:10 ` [PATCH 09/10] drm/i915: add support for checking RPM atomic sections Imre Deak
2015-12-16 11:06 ` Joonas Lahtinen
2015-12-16 11:18 ` Daniel Vetter
2015-12-16 22:53 ` Imre Deak
2015-12-15 18:10 ` [PATCH 10/10] drm/i915: check that we are in an RPM atomic section in GGTT PTE updaters Imre Deak
2015-12-17 14:44 ` [PATCH v4 00/10] drm/i915: improve the RPM device suspended assert Imre Deak
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1450262667.4707.9.camel@linux.intel.com \
--to=joonas.lahtinen@linux.intel.com \
--cc=imre.deak@intel.com \
--cc=intel-gfx@lists.freedesktop.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.