From: Ritesh Harjani <riteshh@codeaurora.org>
To: adrian.hunter@intel.com
Cc: ulf.hansson@linaro.org, linux-mmc@vger.kernel.org,
shawn.lin@rock-chips.com, linux-arm-msm@vger.kernel.org,
georgi.djakov@linaro.org, alex.lemberg@sandisk.com,
mateusz.nowak@intel.com, Yuliy.Izrailov@sandisk.com,
asutoshd@codeaurora.org, david.griego@linaro.org,
stummala@codeaurora.org, venkatg@codeaurora.org,
pramod.gurav@linaro.org, bjorn.andersson@linaro.org,
Ritesh Harjani <riteshh@codeaurora.org>
Subject: [PATCH v4 1/9] mmc: sdhci-msm: Change poor style writel/readl of registers
Date: Wed, 24 Aug 2016 15:33:36 +0530 [thread overview]
Message-ID: <1472033024-14890-2-git-send-email-riteshh@codeaurora.org> (raw)
In-Reply-To: <1472033024-14890-1-git-send-email-riteshh@codeaurora.org>
This patch changes the poor style of writel/readl registers
into more readable format. Also to avoid mixed style format
of readl/writel in sdhci-msm driver.
Signed-off-by: Ritesh Harjani <riteshh@codeaurora.org>
Acked-by: Adrian Hunter <adrian.hunter@intel.com>
---
drivers/mmc/host/sdhci-msm.c | 54 ++++++++++++++++++++++++++------------------
1 file changed, 32 insertions(+), 22 deletions(-)
diff --git a/drivers/mmc/host/sdhci-msm.c b/drivers/mmc/host/sdhci-msm.c
index 8ef44a2a..42f42aa 100644
--- a/drivers/mmc/host/sdhci-msm.c
+++ b/drivers/mmc/host/sdhci-msm.c
@@ -137,8 +137,9 @@ static int msm_config_cm_dll_phase(struct sdhci_host *host, u8 phase)
writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG);
/* Set CK_OUT_EN bit of DLL_CONFIG register to 1. */
- writel_relaxed((readl_relaxed(host->ioaddr + CORE_DLL_CONFIG)
- | CORE_CK_OUT_EN), host->ioaddr + CORE_DLL_CONFIG);
+ config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG);
+ config |= CORE_CK_OUT_EN;
+ writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG);
/* Wait until CK_OUT_EN bit of DLL_CONFIG register becomes '1' */
rc = msm_dll_poll_ck_out_en(host, 1);
@@ -305,6 +306,7 @@ static int msm_init_cm_dll(struct sdhci_host *host)
struct mmc_host *mmc = host->mmc;
int wait_cnt = 50;
unsigned long flags;
+ u32 config = 0;
spin_lock_irqsave(&host->lock, flags);
@@ -313,33 +315,40 @@ static int msm_init_cm_dll(struct sdhci_host *host)
* tuning is in progress. Keeping PWRSAVE ON may
* turn off the clock.
*/
- writel_relaxed((readl_relaxed(host->ioaddr + CORE_VENDOR_SPEC)
- & ~CORE_CLK_PWRSAVE), host->ioaddr + CORE_VENDOR_SPEC);
+ config = readl_relaxed(host->ioaddr + CORE_VENDOR_SPEC);
+ config &= ~CORE_CLK_PWRSAVE;
+ writel_relaxed(config, host->ioaddr + CORE_VENDOR_SPEC);
/* Write 1 to DLL_RST bit of DLL_CONFIG register */
- writel_relaxed((readl_relaxed(host->ioaddr + CORE_DLL_CONFIG)
- | CORE_DLL_RST), host->ioaddr + CORE_DLL_CONFIG);
+ config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG);
+ config |= CORE_DLL_RST;
+ writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG);
/* Write 1 to DLL_PDN bit of DLL_CONFIG register */
- writel_relaxed((readl_relaxed(host->ioaddr + CORE_DLL_CONFIG)
- | CORE_DLL_PDN), host->ioaddr + CORE_DLL_CONFIG);
+ config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG);
+ config |= CORE_DLL_PDN;
+ writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG);
msm_cm_dll_set_freq(host);
/* Write 0 to DLL_RST bit of DLL_CONFIG register */
- writel_relaxed((readl_relaxed(host->ioaddr + CORE_DLL_CONFIG)
- & ~CORE_DLL_RST), host->ioaddr + CORE_DLL_CONFIG);
+ config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG);
+ config &= ~CORE_DLL_RST;
+ writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG);
/* Write 0 to DLL_PDN bit of DLL_CONFIG register */
- writel_relaxed((readl_relaxed(host->ioaddr + CORE_DLL_CONFIG)
- & ~CORE_DLL_PDN), host->ioaddr + CORE_DLL_CONFIG);
+ config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG);
+ config &= ~CORE_DLL_PDN;
+ writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG);
/* Set DLL_EN bit to 1. */
- writel_relaxed((readl_relaxed(host->ioaddr + CORE_DLL_CONFIG)
- | CORE_DLL_EN), host->ioaddr + CORE_DLL_CONFIG);
+ config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG);
+ config |= CORE_DLL_EN;
+ writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG);
/* Set CK_OUT_EN bit to 1. */
- writel_relaxed((readl_relaxed(host->ioaddr + CORE_DLL_CONFIG)
- | CORE_CK_OUT_EN), host->ioaddr + CORE_DLL_CONFIG);
+ config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG);
+ config |= CORE_CK_OUT_EN;
+ writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG);
/* Wait until DLL_LOCK bit of DLL_STATUS register becomes '1' */
while (!(readl_relaxed(host->ioaddr + CORE_DLL_STATUS) &
@@ -536,7 +545,7 @@ static int sdhci_msm_probe(struct platform_device *pdev)
struct resource *core_memres;
int ret;
u16 host_version, core_minor;
- u32 core_version, caps;
+ u32 core_version, config;
u8 core_major;
host = sdhci_pltfm_init(pdev, &sdhci_msm_pdata, sizeof(*msm_host));
@@ -605,8 +614,9 @@ static int sdhci_msm_probe(struct platform_device *pdev)
}
/* Reset the core and Enable SDHC mode */
- writel_relaxed(readl_relaxed(msm_host->core_mem + CORE_POWER) |
- CORE_SW_RST, msm_host->core_mem + CORE_POWER);
+ config = readl_relaxed(msm_host->core_mem + CORE_POWER);
+ config |= CORE_SW_RST;
+ writel_relaxed(config, msm_host->core_mem + CORE_POWER);
/* SW reset can take upto 10HCLK + 15MCLK cycles. (min 40us) */
usleep_range(1000, 5000);
@@ -636,9 +646,9 @@ static int sdhci_msm_probe(struct platform_device *pdev)
* controller versions and must be explicitly enabled.
*/
if (core_major >= 1 && core_minor != 0x11 && core_minor != 0x12) {
- caps = readl_relaxed(host->ioaddr + SDHCI_CAPABILITIES);
- caps |= SDHCI_CAN_VDD_300 | SDHCI_CAN_DO_8BIT;
- writel_relaxed(caps, host->ioaddr +
+ config = readl_relaxed(host->ioaddr + SDHCI_CAPABILITIES);
+ config |= SDHCI_CAN_VDD_300 | SDHCI_CAN_DO_8BIT;
+ writel_relaxed(config, host->ioaddr +
CORE_VENDOR_SPEC_CAPABILITIES0);
}
--
The Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project.
next prev parent reply other threads:[~2016-08-24 10:03 UTC|newest]
Thread overview: 19+ messages / expand[flat|nested] mbox.gz Atom feed top
2016-08-24 10:03 [PATCH v4 0/9] mmc: sdhci-msm: Add clk-rates and DDR support Ritesh Harjani
2016-08-24 10:03 ` Ritesh Harjani [this message]
2016-08-24 10:03 ` [PATCH v4 2/9] mmc: sdhci-msm: Update DLL reset sequence Ritesh Harjani
2016-08-24 10:03 ` [PATCH v4 3/9] mmc: sdhci-msm: add pltfm_data support to get clk-rates from DT Ritesh Harjani
2016-08-25 22:27 ` Stephen Boyd
2016-08-30 14:12 ` Ritesh Harjani
[not found] ` <1a44bb54-d88c-737d-7fb1-e7c3597ac03b-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>
2016-09-07 16:14 ` Stephen Boyd
2016-09-12 6:17 ` Ritesh Harjani
2016-10-04 9:33 ` Ritesh Harjani
2016-09-12 7:33 ` Arnd Bergmann
2016-09-27 5:06 ` Ritesh Harjani
2016-08-24 10:03 ` [PATCH v4 4/9] ARM: dts: qcom: Add clk-rates to sdhc1 & sdhc2 Ritesh Harjani
2016-08-24 10:03 ` [PATCH v4 5/9] mmc: sdhci-msm: Add get_min_clock() and get_max_clock() callback Ritesh Harjani
2016-08-24 10:03 ` [PATCH v4 6/9] mmc: sdhci-msm: Enable few quirks Ritesh Harjani
2016-08-24 10:03 ` [PATCH v4 7/9] mmc: sdhci-msm: Implement set_clock callback for sdhci-msm Ritesh Harjani
2016-08-24 10:03 ` [PATCH v4 8/9] mmc: sdhci-msm: Add clock changes for DDR mode Ritesh Harjani
2016-08-29 13:17 ` Adrian Hunter
2016-08-30 14:16 ` Ritesh Harjani
2016-08-24 10:03 ` [PATCH v4 9/9] arm64: dts: qcom: msm8916: Add ddr support to sdhc1 Ritesh Harjani
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1472033024-14890-2-git-send-email-riteshh@codeaurora.org \
--to=riteshh@codeaurora.org \
--cc=Yuliy.Izrailov@sandisk.com \
--cc=adrian.hunter@intel.com \
--cc=alex.lemberg@sandisk.com \
--cc=asutoshd@codeaurora.org \
--cc=bjorn.andersson@linaro.org \
--cc=david.griego@linaro.org \
--cc=georgi.djakov@linaro.org \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-mmc@vger.kernel.org \
--cc=mateusz.nowak@intel.com \
--cc=pramod.gurav@linaro.org \
--cc=shawn.lin@rock-chips.com \
--cc=stummala@codeaurora.org \
--cc=ulf.hansson@linaro.org \
--cc=venkatg@codeaurora.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.