Re: aic7xxx errors with 2.4.8-ac7 on 440gx mobo

[Cliff Albert <cliff@oisec.net>]

> > > >I'm getting similair errors on 2.4.8-ac7 on my P2B-S motherboard using
> > > >the NEW AIC7xxx driver, the old isn't experiencing these problems. Further
> > > >i've been getting these errors since 2.4.3.
> > > >
> > > >> booting with append="noapic", gives the same errors
> > > 
> > > Can you send me the full messages when you boot with "aic7xxx=verbose"?
> > > That should help indicate the source of your problems.  I also
> > > need to see the devices that are attached to the bus, so a full dmesg
> > > from a successful boot with the old driver would be helpful.
> > 
> > Well booting is successful on my board, but the same errors that almost
> > everyone is getting are the same i'm getting. I just turned on verbose.
> > 
> > Most debugging info i already send to the linux-kernel mailinglist, i'll
> > forward it on to you. The verbose info will be send also in about a few 
> > hours.
> 
> And here they are, the dmesg is my bootup dmesg with the devices drivers 
> and stuff, and the second dmesg is the actual errors (verbose turned on)

Some more research pointed out that the errors/lock of the scsi bus always 
appears about 20 seconds after kernel load when i cold boot the machine. 
With a warm boot the machine gives these errors/lock at random times.

-- 
Cliff Albert		ripe:  CA3348-RIPE 	IPng: IPv6 Deployment
cliff@ipng.nl		6bone: CA2-6BONE	http://www.ipng.nl/