Re: [PATCH] phy: export phy_mii_ioctl

[Juergen Beisert <jbe@pengutronix.de>]

Pedro,

On Wednesday 19 September 2007 10:54, Pedro Luis D. L. wrote:
> I=B4m also working with a Phytec pcm030, but I can=B4t get it booted...
> Which kernel are you using?
> I tried to apply the 7 bestcomm patches from Sylvain and patch over these
> with this new ones that Domen released. The base kernel I=B4m using is
> 2.6.22.6 from kernel.org.
> Although I used the patch that creates pcm030.c in arch/platforms/52xx/ a=
nd
> compiled using this file, it gets halted at booting time.
>
> Bytes transferred =3D 5091 (13e3 hex)
> ## Booting image at 00500000 ...
>    Image Name:   Linux-2.6.22.6
>    Created:      2007-09-19   8:53:02 UTC
>    Image Type:   PowerPC Linux Kernel Image (gzip compressed)
>    Data Size:    1196911 Bytes =3D  1.1 MB
>    Load Address: 00000000
>    Entry Point:  00000000
>    Verifying Checksum ... OK
>    Uncompressing Kernel Image ... OK
>    Booting using flat device tree at 0x400000
>
> (No more output and boot is halted)

Check your oftree! Most of the time this behaviour means its a wrong oftree=
 in=20
use.

Juergen

=2D-=20
Dipl.-Ing. Juergen Beisert | http://www.pengutronix.de
=A0Pengutronix - Linux Solutions for Science and Industry
=A0   Handelsregister: Amtsgericht Hildesheim, HRA 2686
=A0 =A0 =A0    Vertretung Sued/Muenchen, Germany
   Phone: +49-8766-939 228 |  Fax: +49-5121-206917-9