Re: [PATCH 3/4] spi: Add OF binding support for SPI busses

[David Brownell <david-b-yBeKhBN/0LDR7s880joybQ@public.gmane.org>]

On Wednesday 21 May 2008, Grant Likely wrote:
> > spi-controller {
> >        #address-cells = 2;
> >        #size-cells = 0;
> >        some-device@0,f000 { reg = < 0 f000 >; } // CS 0, SPI address f000
> >        some-device@1,f000 { reg = < 1 f000 >; } // CS 1, SPI address f000
> >        some-device@1,ff00 { reg = < 1 ff00 >; } // CS 1, SPI address ff00
> > }
> 
> For SPI the CS # *is* the address.  :-)
> 
> Unlike I2C, SPI doesn't impose any protocol on the data.  It is all
> anonymous data out, anonymous data in, a clock and a chip select.

Very true ... but then there are SPI chips which embed addressing.

I have in mind the mcp23s08 (and mcp23s17) GPIO expanders, which
support up to four chips wired in parallel on a given chipselect.
The devices are distinguished by how two address pins are wired;
and two bits in the command byte must match them.  (I think they
just recycled an I2C design into the SPI world.)

- Dave

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/