Re: [PATCH v3 3/4] powerpc: NAND: FSL UPM: document new bindings

[Anton Vorontsov <avorontsov@ru.mvista.com>]

On Wed, Mar 25, 2009 at 11:08:20AM +0100, Wolfgang Grandegger wrote:
> This patch adds documentation for the new NAND FSL UPM bindings for:
> 
>  NAND: FSL-UPM: add multi chip support
>  NAND: FSL-UPM: Add wait flags to support board/chip specific delays
> 
> Signed-off-by: Wolfgang Grandegger <wg@grandegger.com>
> ---

To me it looks good.

Acked-by: Anton Vorontsov <avorontsov@ru.mvista.com>

>  .../powerpc/dts-bindings/fsl/upm-nand.txt          |   39 +++++++++++++++++++-
>  1 files changed, 37 insertions(+), 2 deletions(-)
> 
> diff --git a/Documentation/powerpc/dts-bindings/fsl/upm-nand.txt b/Documentation/powerpc/dts-bindings/fsl/upm-nand.txt
> index 84a04d5..0272e70 100644
> --- a/Documentation/powerpc/dts-bindings/fsl/upm-nand.txt
> +++ b/Documentation/powerpc/dts-bindings/fsl/upm-nand.txt
> @@ -5,9 +5,22 @@ Required properties:
>  - reg : should specify localbus chip select and size used for the chip.
>  - fsl,upm-addr-offset : UPM pattern offset for the address latch.
>  - fsl,upm-cmd-offset : UPM pattern offset for the command latch.
> -- gpios : may specify optional GPIO connected to the Ready-Not-Busy pin.
>  
> -Example:
> +Optional properties:
> +- fsl,upm-wait-flags : add chip-dependent short delays after running the
> +  		       UPM pattern (0x1), after writing a data byte (0x2)
> +		       or after writing out a buffer (0x4).
> +- gpios : may specify optional GPIOs connected to the Ready-Not-Busy pins
> +	  (R/B#). For multi-chip devices, "num-chips" GPIO definitions are
> +	  required.
> +- chip-delay : chip dependent delay for transfering data from array to
> +	       read registers (tR). Required if property "gpios" is not
> +	       used (R/B# pins not connected).
> +- num-chips : number of chips per device for multi-chip support.
> +- chip-offset : address offset between chips for multi-chip support. The
> + 		corresponding address lines are used to select the chip.
> +
> +Examples:
>  
>  upm@1,0 {
>  	compatible = "fsl,upm-nand";
> @@ -26,3 +39,25 @@ upm@1,0 {
>  		};
>  	};
>  };
> +
> +upm@3,0 {
> +	compatible = "fsl,upm-nand";
> +	reg = <3 0x0 0x800>;
> +	fsl,upm-addr-offset = <0x10>;
> +	fsl,upm-cmd-offset = <0x08>;
> +	fsl,upm-wait-flags = <0x5>;
> +	/* Multi-chip device */
> +	num-chips = <2>;
> +	chip-offset = <0x200>;
> +	chip-delay = <25>; // in micro-seconds
> +
> +	nand@0 {
> +		#address-cells = <1>;
> +		#size-cells = <1>;
> +
> +		partition@0 {
> +			    label = "fs";
> +			    reg = <0x00000000 0x10000000>;
> +		};
> +	};
> +};
> -- 
> 1.6.0.6

-- 
Anton Vorontsov
email: cbouatmailru@gmail.com
irc://irc.freenode.net/bd2