Re: [RFC] multiqueue changes

[Jarek Poplawski <jarkao2@gmail.com>]

On Sat, Oct 31, 2009 at 10:25:52AM -0700, Michael Chan wrote:
> 
> On Fri, 2009-10-30 at 03:00 -0700, Jarek Poplawski wrote:
> > On Thu, Oct 29, 2009 at 11:12:39PM +0100, Patrick McHardy wrote:
...
> > > I currently can't see any purpose in decreasing num_tx_queues after
> > > registration instead of real_num_tx_queues.
> > 
> > I agree, but since Eric's example shows some drivers do it (almost)
> > like this, I'd prefer authors/maintainers answer this question.
> > 
> 
> We need the netdev and the private structure at the beginning of
> ->probe() to store values as we probe the device.  Later on in
> ->probe(), we'll know whether the device supports MSI-X and multiqueue.
> If we successfully enable MSI-X in ->ndo_open(), tx multiqueue will be
> used.
> 
> So if we can separate the allocation of the netdev and the private
> structure from the tx queues, we can allocate and set the exact number
> of num_tx_queues in ->ndo_open().

There is a question if we can predict in ->probe() MSI-X should be
successfully enabled in ->ndo_open() for probed hardware. If so,
then it could go e.g. like this:
->probe()
	...
	dev = alloc_etherdev_mq(sizeof(*bp), 1)
	...
	if (MSI-X_available && device_supports_MSI-X_and_multiqueue)
		realloc_netdev_mq(dev, TX_MAX_RINGS)
	register_netdev(dev)

->ndo_open()
	if (!enabled_MSI-X)
		/* something gone wrong but it's an exception */
		dev->real_num_tx_queues = 1

Otherwise, (re)allocation in ->ndo_open() would need to answer some
questions about reinitializing scheduler vs preserving qdisc stats
between opens.

Jarek P.