From: Daniel Mack <daniel@caiaq.de>
To: Mark Brown <broonie@opensource.wolfsonmicro.com>
Cc: alsa-devel@alsa-project.org, Timur Tabi <timur@freescale.com>,
Liam Girdwood <lrg@slimlogic.co.uk>
Subject: Re: [PATCH] ALSA: ASoc: Add regulator support to CS4270 codec driver
Date: Fri, 27 Nov 2009 13:41:39 +0100 [thread overview]
Message-ID: <20091127124139.GR14091@buzzloop.caiaq.de> (raw)
In-Reply-To: <20091127112550.GA29821@rakim.wolfsonmicro.main>
On Fri, Nov 27, 2009 at 11:25:51AM +0000, Mark Brown wrote:
> On Thu, Nov 26, 2009 at 06:42:45PM +0100, Daniel Mack wrote:
> > +
> > + switch (level) {
> > + case SND_SOC_BIAS_ON:
> > + ret = regulator_enable(cs4270->vd_reg);
> > + if (ret < 0)
> > + return ret;
> > + ret = regulator_enable(cs4270->vlc_reg);
> > + if (ret < 0)
> > + return ret;
> > + /* fall thru */
>
> I'd expect these to just be enabled on OFF->STANDBY (or in the suspend
> code indeed) - you'll need to restore the register cache after the
> digital comes up anyway.
>
> Also, you'll leak references since you only turn them off when going
> into OFF but enable them every time you go to ON.
Ok, agreed. Next try below.
Thanks,
Daniel
>From 2a36f34232b060ad6a12e4260e24d70d491e7dcb Mon Sep 17 00:00:00 2001
From: Daniel Mack <daniel@caiaq.de>
Date: Wed, 25 Nov 2009 15:31:25 +0100
Subject: [PATCH] ALSA: ASoc: Add regulator support to CS4270 codec driver
Signed-off-by: Daniel Mack <daniel@caiaq.de>
Cc: Mark Brown <broonie@opensource.wolfsonmicro.com>
Cc: Timur Tabi <timur@freescale.com>
Cc: Liam Girdwood <lrg@slimlogic.co.uk>
---
sound/soc/codecs/cs4270.c | 114 ++++++++++++++++++++++++++++++++++++++++++++-
1 files changed, 112 insertions(+), 2 deletions(-)
diff --git a/sound/soc/codecs/cs4270.c b/sound/soc/codecs/cs4270.c
index 8069023..34cd97d 100644
--- a/sound/soc/codecs/cs4270.c
+++ b/sound/soc/codecs/cs4270.c
@@ -28,6 +28,7 @@
#include <sound/initval.h>
#include <linux/i2c.h>
#include <linux/delay.h>
+#include <linux/regulator/consumer.h>
#include "cs4270.h"
@@ -114,6 +115,12 @@ struct cs4270_private {
unsigned int mode; /* The mode (I2S or left-justified) */
unsigned int slave_mode;
unsigned int manual_mute;
+
+ /* power domain regulators */
+ struct regulator *va_reg;
+ struct regulator *vd_reg;
+ struct regulator *vlc_reg;
+ bool va_reg_enabled;
};
/**
@@ -458,6 +465,50 @@ static int cs4270_hw_params(struct snd_pcm_substream *substream,
}
/**
+ * cs4270_set_bias_level - catches BIAS level changes
+ * @dai: the SOC DAI
+ * @level: the new BIAS level
+ *
+ * This function controls the voltage regulators to properly
+ * power up/down the voltage regulator domains
+ */
+
+static int cs4270_set_bias_level(struct snd_soc_codec *codec,
+ enum snd_soc_bias_level level)
+{
+ int ret;
+ struct cs4270_private *cs4270 = codec->private_data;
+
+ switch (level) {
+ case SND_SOC_BIAS_ON:
+ case SND_SOC_BIAS_PREPARE:
+ if (!cs4270->va_reg_enabled) {
+ ret = regulator_enable(cs4270->va_reg);
+ if (ret < 0)
+ return ret;
+
+ cs4270->va_reg_enabled = true;
+ }
+
+ break;
+ case SND_SOC_BIAS_STANDBY:
+ case SND_SOC_BIAS_OFF:
+ if (cs4270->va_reg_enabled) {
+ ret = regulator_disable(cs4270->va_reg);
+ if (ret < 0)
+ return ret;
+
+ cs4270->va_reg_enabled = false;
+ }
+
+ break;
+ }
+
+ codec->bias_level = level;
+ return 0;
+}
+
+/**
* cs4270_dai_mute - enable/disable the CS4270 external mute
* @dai: the SOC DAI
* @mute: 0 = disable mute, 1 = enable mute
@@ -579,6 +630,7 @@ static int cs4270_probe(struct platform_device *pdev)
{
struct snd_soc_device *socdev = platform_get_drvdata(pdev);
struct snd_soc_codec *codec = cs4270_codec;
+ struct cs4270_private *cs4270 = codec->private_data;
int ret;
/* Connect the codec to the socdev. snd_soc_new_pcms() needs this. */
@@ -599,6 +651,25 @@ static int cs4270_probe(struct platform_device *pdev)
goto error_free_pcms;
}
+ /* get the power supply regulators */
+ cs4270->va_reg = regulator_get(codec->dev, "va");
+ cs4270->vd_reg = regulator_get(codec->dev, "vd");
+ cs4270->vlc_reg = regulator_get(codec->dev, "vlc");
+
+ if (IS_ERR(cs4270->va_reg) ||
+ IS_ERR(cs4270->vd_reg) ||
+ IS_ERR(cs4270->vlc_reg)) {
+ dev_err(codec->dev,
+ "failed to get supplies for device %s\n",
+ dev_name(codec->dev));
+ goto error_free_pcms;
+ }
+
+ regulator_enable(cs4270->vd_reg);
+ regulator_enable(cs4270->vlc_reg);
+
+ cs4270_set_bias_level(codec, SND_SOC_BIAS_STANDBY);
+
/* And finally, register the socdev */
ret = snd_soc_init_card(socdev);
if (ret < 0) {
@@ -609,6 +680,10 @@ static int cs4270_probe(struct platform_device *pdev)
return 0;
error_free_pcms:
+ regulator_put(cs4270->va_reg);
+ regulator_put(cs4270->vd_reg);
+ regulator_put(cs4270->vlc_reg);
+
snd_soc_free_pcms(socdev);
return ret;
@@ -623,9 +698,21 @@ error_free_pcms:
static int cs4270_remove(struct platform_device *pdev)
{
struct snd_soc_device *socdev = platform_get_drvdata(pdev);
+ struct snd_soc_codec *codec = cs4270_codec;
+ struct cs4270_private *cs4270 = codec->private_data;
snd_soc_free_pcms(socdev);
+ if (cs4270->va_reg_enabled)
+ regulator_disable(cs4270->va_reg);
+
+ regulator_disable(cs4270->vd_reg);
+ regulator_disable(cs4270->vlc_reg);
+
+ regulator_put(cs4270->va_reg);
+ regulator_put(cs4270->vd_reg);
+ regulator_put(cs4270->vlc_reg);
+
return 0;
};
@@ -699,6 +786,8 @@ static int cs4270_i2c_probe(struct i2c_client *i2c_client,
codec->write = cs4270_i2c_write;
codec->reg_cache = cs4270->reg_cache;
codec->reg_cache_size = CS4270_NUMREGS;
+ codec->bias_level = SND_SOC_BIAS_OFF;
+ codec->set_bias_level = cs4270_set_bias_level;
/* The I2C interface is set up, so pre-fill our register cache */
@@ -822,17 +911,38 @@ static int cs4270_i2c_resume(struct i2c_client *client)
static int cs4270_soc_suspend(struct platform_device *pdev, pm_message_t mesg)
{
struct snd_soc_codec *codec = cs4270_codec;
- int reg = snd_soc_read(codec, CS4270_PWRCTL) | CS4270_PWRCTL_PDN_ALL;
+ struct cs4270_private *cs4270 = codec->private_data;
+ int reg, ret;
- return snd_soc_write(codec, CS4270_PWRCTL, reg);
+ reg = snd_soc_read(codec, CS4270_PWRCTL) | CS4270_PWRCTL_PDN_ALL;
+ if (reg < 0)
+ return reg;
+
+ ret = snd_soc_write(codec, CS4270_PWRCTL, reg);
+ if (ret < 0)
+ return ret;
+
+ ret = cs4270_set_bias_level(codec, SND_SOC_BIAS_OFF);
+ if (ret < 0)
+ return ret;
+
+ regulator_disable(cs4270->vd_reg);
+ regulator_disable(cs4270->vlc_reg);
+
+ return 0;
}
static int cs4270_soc_resume(struct platform_device *pdev)
{
struct snd_soc_codec *codec = cs4270_codec;
+ struct cs4270_private *cs4270 = codec->private_data;
struct i2c_client *i2c_client = codec->control_data;
int reg;
+ regulator_enable(cs4270->vd_reg);
+ regulator_enable(cs4270->vlc_reg);
+ cs4270_set_bias_level(codec, SND_SOC_BIAS_STANDBY);
+
/* In case the device was put to hard reset during sleep, we need to
* wait 500ns here before any I2C communication. */
ndelay(500);
--
1.6.5.2
next prev parent reply other threads:[~2009-11-27 12:41 UTC|newest]
Thread overview: 30+ messages / expand[flat|nested] mbox.gz Atom feed top
2009-11-25 14:36 [PATCH] ALSA: ASoc: Add regulator support to CS4270 codec driver Daniel Mack
2009-11-25 15:01 ` Mark Brown
2009-11-25 15:20 ` Daniel Mack
2009-11-25 15:38 ` Mark Brown
2009-11-25 15:46 ` Daniel Mack
2009-11-26 15:48 ` Daniel Mack
2009-11-26 16:03 ` Mark Brown
2009-11-26 17:42 ` Daniel Mack
2009-11-27 11:25 ` Mark Brown
2009-11-27 12:41 ` Daniel Mack [this message]
2009-11-27 13:32 ` Mark Brown
2009-11-28 20:23 ` Timur Tabi
2009-11-28 20:31 ` Mark Brown
2009-11-28 22:18 ` Timur Tabi
2009-11-29 0:44 ` Daniel Mack
2009-11-29 4:34 ` Timur Tabi
2009-11-29 8:35 ` Daniel Mack
2009-11-30 10:12 ` Daniel Mack
[not found] ` <5610599F537DD74A8D1F5CC946A7507303478C40@az33exm25.fsl.freescale.net>
2009-11-30 12:01 ` Mark Brown
2009-11-30 12:36 ` Daniel Mack
2009-11-30 15:57 ` Daniel Mack
2009-11-30 16:12 ` Mark Brown
2009-11-30 16:51 ` Daniel Mack
2009-11-30 16:56 ` Daniel Mack
2009-12-04 12:00 ` Daniel Mack
2009-12-04 12:07 ` Mark Brown
2009-12-05 2:54 ` Timur Tabi
2009-12-05 3:51 ` Mark Brown
2009-12-05 17:03 ` Timur Tabi
2009-12-07 13:16 ` Mark Brown
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20091127124139.GR14091@buzzloop.caiaq.de \
--to=daniel@caiaq.de \
--cc=alsa-devel@alsa-project.org \
--cc=broonie@opensource.wolfsonmicro.com \
--cc=lrg@slimlogic.co.uk \
--cc=timur@freescale.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.