From: Daniel Mack <daniel@caiaq.de>
To: Timur Tabi <timur@freescale.com>
Cc: "alsa-devel@alsa-project.org" <alsa-devel@alsa-project.org>,
Mark Brown <broonie@opensource.wolfsonmicro.com>,
Liam Girdwood <lrg@slimlogic.co.uk>
Subject: Re: [PATCH] ALSA: ASoc: Add regulator support to CS4270 codec driver
Date: Mon, 30 Nov 2009 11:12:23 +0100 [thread overview]
Message-ID: <20091130101223.GZ29442@buzzloop.caiaq.de> (raw)
In-Reply-To: <20091129083554.GC14091@buzzloop.caiaq.de>
On Sun, Nov 29, 2009 at 09:35:54AM +0100, Daniel Mack wrote:
> Anyway - I'll rebase the driver to 'for-2.6.33' so you can give it a
> try.
See below.
Daniel
>From 40f036c11cf36d6832431a4fda4e1ab1a2cf5b2e Mon Sep 17 00:00:00 2001
From: Daniel Mack <daniel@caiaq.de>
Date: Wed, 25 Nov 2009 15:31:25 +0100
Subject: [PATCH] ALSA: ASoc: Add regulator support to CS4270 codec driver
Signed-off-by: Daniel Mack <daniel@caiaq.de>
Cc: Mark Brown <broonie@opensource.wolfsonmicro.com>
Cc: Timur Tabi <timur@freescale.com>
Cc: Liam Girdwood <lrg@slimlogic.co.uk>
---
sound/soc/codecs/cs4270.c | 114 ++++++++++++++++++++++++++++++++++++++++++++-
1 files changed, 112 insertions(+), 2 deletions(-)
diff --git a/sound/soc/codecs/cs4270.c b/sound/soc/codecs/cs4270.c
index ffe122d..279a644 100644
--- a/sound/soc/codecs/cs4270.c
+++ b/sound/soc/codecs/cs4270.c
@@ -28,6 +28,7 @@
#include <sound/initval.h>
#include <linux/i2c.h>
#include <linux/delay.h>
+#include <linux/regulator/consumer.h>
#include "cs4270.h"
@@ -114,6 +115,12 @@ struct cs4270_private {
unsigned int mode; /* The mode (I2S or left-justified) */
unsigned int slave_mode;
unsigned int manual_mute;
+
+ /* power domain regulators */
+ struct regulator *va_reg;
+ struct regulator *vd_reg;
+ struct regulator *vlc_reg;
+ bool va_reg_enabled;
};
/**
@@ -458,6 +465,50 @@ static int cs4270_hw_params(struct snd_pcm_substream *substream,
}
/**
+ * cs4270_set_bias_level - catches BIAS level changes
+ * @dai: the SOC DAI
+ * @level: the new BIAS level
+ *
+ * This function controls the voltage regulators to properly
+ * power up/down the voltage regulator domains
+ */
+
+static int cs4270_set_bias_level(struct snd_soc_codec *codec,
+ enum snd_soc_bias_level level)
+{
+ int ret;
+ struct cs4270_private *cs4270 = codec->private_data;
+
+ switch (level) {
+ case SND_SOC_BIAS_ON:
+ case SND_SOC_BIAS_PREPARE:
+ if (!cs4270->va_reg_enabled) {
+ ret = regulator_enable(cs4270->va_reg);
+ if (ret < 0)
+ return ret;
+
+ cs4270->va_reg_enabled = true;
+ }
+
+ break;
+ case SND_SOC_BIAS_STANDBY:
+ case SND_SOC_BIAS_OFF:
+ if (cs4270->va_reg_enabled) {
+ ret = regulator_disable(cs4270->va_reg);
+ if (ret < 0)
+ return ret;
+
+ cs4270->va_reg_enabled = false;
+ }
+
+ break;
+ }
+
+ codec->bias_level = level;
+ return 0;
+}
+
+/**
* cs4270_dai_mute - enable/disable the CS4270 external mute
* @dai: the SOC DAI
* @mute: 0 = disable mute, 1 = enable mute
@@ -579,6 +630,7 @@ static int cs4270_probe(struct platform_device *pdev)
{
struct snd_soc_device *socdev = platform_get_drvdata(pdev);
struct snd_soc_codec *codec = cs4270_codec;
+ struct cs4270_private *cs4270 = codec->private_data;
int ret;
/* Connect the codec to the socdev. snd_soc_new_pcms() needs this. */
@@ -599,9 +651,32 @@ static int cs4270_probe(struct platform_device *pdev)
goto error_free_pcms;
}
+ /* get the power supply regulators */
+ cs4270->va_reg = regulator_get(codec->dev, "va");
+ cs4270->vd_reg = regulator_get(codec->dev, "vd");
+ cs4270->vlc_reg = regulator_get(codec->dev, "vlc");
+
+ if (IS_ERR(cs4270->va_reg) ||
+ IS_ERR(cs4270->vd_reg) ||
+ IS_ERR(cs4270->vlc_reg)) {
+ dev_err(codec->dev,
+ "failed to get supplies for device %s\n",
+ dev_name(codec->dev));
+ goto error_free_pcms;
+ }
+
+ regulator_enable(cs4270->vd_reg);
+ regulator_enable(cs4270->vlc_reg);
+
+ cs4270_set_bias_level(codec, SND_SOC_BIAS_STANDBY);
+
return 0;
error_free_pcms:
+ regulator_put(cs4270->va_reg);
+ regulator_put(cs4270->vd_reg);
+ regulator_put(cs4270->vlc_reg);
+
snd_soc_free_pcms(socdev);
return ret;
@@ -616,9 +691,21 @@ error_free_pcms:
static int cs4270_remove(struct platform_device *pdev)
{
struct snd_soc_device *socdev = platform_get_drvdata(pdev);
+ struct snd_soc_codec *codec = cs4270_codec;
+ struct cs4270_private *cs4270 = codec->private_data;
snd_soc_free_pcms(socdev);
+ if (cs4270->va_reg_enabled)
+ regulator_disable(cs4270->va_reg);
+
+ regulator_disable(cs4270->vd_reg);
+ regulator_disable(cs4270->vlc_reg);
+
+ regulator_put(cs4270->va_reg);
+ regulator_put(cs4270->vd_reg);
+ regulator_put(cs4270->vlc_reg);
+
return 0;
};
@@ -692,6 +779,8 @@ static int cs4270_i2c_probe(struct i2c_client *i2c_client,
codec->write = cs4270_i2c_write;
codec->reg_cache = cs4270->reg_cache;
codec->reg_cache_size = CS4270_NUMREGS;
+ codec->bias_level = SND_SOC_BIAS_OFF;
+ codec->set_bias_level = cs4270_set_bias_level;
/* The I2C interface is set up, so pre-fill our register cache */
@@ -799,17 +888,38 @@ MODULE_DEVICE_TABLE(i2c, cs4270_id);
static int cs4270_soc_suspend(struct platform_device *pdev, pm_message_t mesg)
{
struct snd_soc_codec *codec = cs4270_codec;
- int reg = snd_soc_read(codec, CS4270_PWRCTL) | CS4270_PWRCTL_PDN_ALL;
+ struct cs4270_private *cs4270 = codec->private_data;
+ int reg, ret;
- return snd_soc_write(codec, CS4270_PWRCTL, reg);
+ reg = snd_soc_read(codec, CS4270_PWRCTL) | CS4270_PWRCTL_PDN_ALL;
+ if (reg < 0)
+ return reg;
+
+ ret = snd_soc_write(codec, CS4270_PWRCTL, reg);
+ if (ret < 0)
+ return ret;
+
+ ret = cs4270_set_bias_level(codec, SND_SOC_BIAS_OFF);
+ if (ret < 0)
+ return ret;
+
+ regulator_disable(cs4270->vd_reg);
+ regulator_disable(cs4270->vlc_reg);
+
+ return 0;
}
static int cs4270_soc_resume(struct platform_device *pdev)
{
struct snd_soc_codec *codec = cs4270_codec;
+ struct cs4270_private *cs4270 = codec->private_data;
struct i2c_client *i2c_client = codec->control_data;
int reg;
+ regulator_enable(cs4270->vd_reg);
+ regulator_enable(cs4270->vlc_reg);
+ cs4270_set_bias_level(codec, SND_SOC_BIAS_STANDBY);
+
/* In case the device was put to hard reset during sleep, we need to
* wait 500ns here before any I2C communication. */
ndelay(500);
--
1.6.5.2
next prev parent reply other threads:[~2009-11-30 10:12 UTC|newest]
Thread overview: 30+ messages / expand[flat|nested] mbox.gz Atom feed top
2009-11-25 14:36 [PATCH] ALSA: ASoc: Add regulator support to CS4270 codec driver Daniel Mack
2009-11-25 15:01 ` Mark Brown
2009-11-25 15:20 ` Daniel Mack
2009-11-25 15:38 ` Mark Brown
2009-11-25 15:46 ` Daniel Mack
2009-11-26 15:48 ` Daniel Mack
2009-11-26 16:03 ` Mark Brown
2009-11-26 17:42 ` Daniel Mack
2009-11-27 11:25 ` Mark Brown
2009-11-27 12:41 ` Daniel Mack
2009-11-27 13:32 ` Mark Brown
2009-11-28 20:23 ` Timur Tabi
2009-11-28 20:31 ` Mark Brown
2009-11-28 22:18 ` Timur Tabi
2009-11-29 0:44 ` Daniel Mack
2009-11-29 4:34 ` Timur Tabi
2009-11-29 8:35 ` Daniel Mack
2009-11-30 10:12 ` Daniel Mack [this message]
[not found] ` <5610599F537DD74A8D1F5CC946A7507303478C40@az33exm25.fsl.freescale.net>
2009-11-30 12:01 ` Mark Brown
2009-11-30 12:36 ` Daniel Mack
2009-11-30 15:57 ` Daniel Mack
2009-11-30 16:12 ` Mark Brown
2009-11-30 16:51 ` Daniel Mack
2009-11-30 16:56 ` Daniel Mack
2009-12-04 12:00 ` Daniel Mack
2009-12-04 12:07 ` Mark Brown
2009-12-05 2:54 ` Timur Tabi
2009-12-05 3:51 ` Mark Brown
2009-12-05 17:03 ` Timur Tabi
2009-12-07 13:16 ` Mark Brown
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20091130101223.GZ29442@buzzloop.caiaq.de \
--to=daniel@caiaq.de \
--cc=alsa-devel@alsa-project.org \
--cc=broonie@opensource.wolfsonmicro.com \
--cc=lrg@slimlogic.co.uk \
--cc=timur@freescale.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.