[PATCH 3/4] fec: add support for Freescale i.MX25 PDK (3DS)

[baruch@tkos.co.il (Baruch Siach)]

Hi Greg,

On Tue, Dec 15, 2009 at 11:27:59AM +1000, Greg Ungerer wrote:
> Hi Baruch,
> 
> Baruch Siach wrote:
> >The i.MX25 PDK uses RMII to communicate with its PHY. This patch adds the
> >necessary bits to make the i.MX25 talk RMII.
> >
> >Signed-off-by: Baruch Siach <baruch@tkos.co.il>
> >---

[snip]

> >+	/* re-enable the gasket */
> >+	writel(2, fep->hwp + FEC_MIIGSK_ENR);
>                              ^^^^^^^^^^^^^^
> 
> This will not compile for some CPU types that use this driver.
> 

[snip]

> >--- a/drivers/net/fec.h
> >+++ b/drivers/net/fec.h
> >@@ -43,6 +43,8 @@
> > #define FEC_R_DES_START		0x180 /* Receive descriptor ring */
> > #define FEC_X_DES_START		0x184 /* Transmit descriptor ring */
> > #define FEC_R_BUFF_SIZE		0x188 /* Maximum receive buff size */
> >+#define FEC_MIIGSK_CFGR		0x300 /* MIIGSK Configuration reg */
> >+#define FEC_MIIGSK_ENR		0x308 /* MIIGSK Enable reg */
> 
> These are defined in a conditional section for certain CPU types.
> There is no definitions for the other "#else" section here.

So, should I put a bogus #define in the other #else section, or put the 
FEC_MIIGSK_* code in an #ifdef section? I guess the latter is the way to go.

baruch

-- 
                                                     ~. .~   Tk Open Systems
=}------------------------------------------------ooO--U--Ooo------------{=
   - baruch at tkos.co.il - tel: +972.2.679.5364, http://www.tkos.co.il -