[U-Boot] [PATCH] i.MX28: Add function to adjust memory parameters

[Marek Vasut <marex@denx.de>]

Dear Stefano Babic,

> On 18/06/2012 16:23, Marek Vasut wrote:
> > Dear Fabio Estevam,
> > 
> >> Hi Marek,
> >> 
> >> On Thu, May 31, 2012 at 3:45 PM, Marek Vasut <marex@denx.de> wrote:
> >>> Call this or similar in your spl_boot.c to adjust the DRAM
> >>> configuration. Actually I think even the following value should fix
> >>> your problem:
> >>> 
> >>> void mx28_adjust_memory_params(uint32_t *dram_vals)
> >>> {
> >>> 
> >>>        dram_vals[0x74 >> 2] = 0x0f02010a;
> >>> 
> >>> }
> >> 
> >> I finally had a chance to try this and my mx28evk can boot again with
> >> your patch + the code above.
> >> 
> >> How do we handle this? Would you send a v2 with this additional code
> >> or should I do it myself after your original patch in this thread gets
> >> applied?
> > 
> > Stefano, can you please apply this? So Fabio can apply his on top of it?
> 
> I do it.
> 
> >> Also, please explain to the mortal folks what 'dram_vals[0x74 >> 2] =
> >> 0x0f02010a;' means.
> > 
> > Well, check that particular register (memory configuration register at
> > +0x74 offset) in the datasheet. It's basically adjusting the number of
> > enabled address row and columns.
> > 
> >> It is not something very trivial to figure out :-)
> > 
> > It actually is, see above ;-)
> 
> I see, but I will never apply a patch programmed in hexadecimal instead
> of plain C ;-)

So ... what do you expect me to do? The register is called HW_DRAM_CTL29 (very 
descriptive) ... do you want me to create a file full of HW_DRAM_CTLnn ?

> 
> Stefano

Best regards,
Marek Vasut