[U-Boot] [PATCH] i.MX28: Add function to adjust memory parameters

[Stefano Babic <sbabic@denx.de>]

On 30/05/2012 07:43, Marek Vasut wrote:
> This function can be overridden at run-time and allows implementors
> of new boards based on the i.MX28 chip to fine-tune the memory params.
> It is possible to write into the dram_vals array because when the SPL
> runs, it is located SRAM. Therefore the location is writable. There is
> no possibility of these data to be read-only.
> 
> Signed-off-by: Marek Vasut <marex@denx.de>
> Cc: Wolfgang Denk <wd@denx.de>
> Cc: Detlev Zundel <dzu@denx.de>
> Cc: Stefano Babic <sbabic@denx.de>
> Cc: Fabio Estevam <festevam@gmail.com>
> ---

Applied to u-boot-imx, thanks.

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================