[U-Boot] [PATCH] gpio: spear_gpio: Fix gpio_set_value() implementation

[Marek Vasut <marex@denx.de>]

Dear Axel Lin,

> In current gpio_set_value() implementation, it always sets the gpio control
> bit no matter the value argument is 0 or 1. Thus the GPIOs never set to
> low. This patch fixes this bug.
> 
> Signed-off-by: Axel Lin <axel.lin@ingics.com>
> ---
>  drivers/gpio/spear_gpio.c | 5 ++++-
>  1 file changed, 4 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/gpio/spear_gpio.c b/drivers/gpio/spear_gpio.c
> index d3c728e..8878608 100644
> --- a/drivers/gpio/spear_gpio.c
> +++ b/drivers/gpio/spear_gpio.c
> @@ -52,7 +52,10 @@ int gpio_set_value(unsigned gpio, int value)
>  {
>  	struct gpio_regs *regs = (struct gpio_regs *)CONFIG_GPIO_BASE;
> 
> -	writel(1 << gpio, &regs->gpiodata[DATA_REG_ADDR(gpio)]);
> +	if (value)
> +		writel(1 << gpio, &regs->gpiodata[DATA_REG_ADDR(gpio)]);
> +	else
> +		writel(0, &regs->gpiodata[DATA_REG_ADDR(gpio)]);

How can this possibly work? Writing 0 to the whole bank will unset all the 
GPIOs, no ?

Best regards,
Marek Vasut