Re: [PATCH v6 36/36] ARM: STi: Add support for the FSM Serial Flash Controller

[Lee Jones <lee.jones@linaro.org>]

> > Here we add the necessary device nodes required for successful device
> > probing and Pinctrl setup for the FSM.
> > 
> > Acked-by: Srinivas Kandagatla <srinivas.kandagatla@st.com>
> > Acked-by Angus Clark <angus.clark@st.com>
> > Signed-off-by: Lee Jones <lee.jones@linaro.org>
> > ---
> >  arch/arm/boot/dts/stih416-pinctrl.dtsi | 13 +++++++++++++
> >  arch/arm/boot/dts/stih416.dtsi         | 13 +++++++++++++
> >  arch/arm/boot/dts/stih41x-b2020.dtsi   |  1 +
> >  arch/arm/boot/dts/stih41x-b2020x.dtsi  | 28 ++++++++++++++++++++++++++++
> >  4 files changed, 55 insertions(+)
> >  create mode 100644 arch/arm/boot/dts/stih41x-b2020x.dtsi

[...]

> > +	soc {
> > +		spifsm: spifsm@fe902000 {
> > +			#address-cells = <1>;
> > +			#size-cells    = <1>;
> > +
> > +			status = "okay";
> > +
> > +			partition@0 {
> > +				label = "Serial Flash 1";
> 
> Are you sure you want spaces in the partition label? I suppose MTD can
> probably handle this fine, but it doesn't seem standard, and it may
> prevent you from using the partition name in certain ways. For instance,
> it might make it harder to use with the "ubi.mtd=" module parameter.
> 
> But otherwise:
> 
> Acked-by: Brian Norris <computersforpeace@gmail.com>

Code fixed and Ack applied.

Thanks Brian.

-- 
Lee Jones
Linaro STMicroelectronics Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog