[PATCHv3 1/7] EDAC, altera: Check parent status for Arria10 EDAC block

[bp@alien8.de (Borislav Petkov)]

On Mon, Jun 13, 2016 at 04:19:06PM -0500, tthayer at opensource.altera.com wrote:
> From: Thor Thayer <tthayer@opensource.altera.com>
> 
> In preparation for the Arria10 ECC modules, check the status
> of the parent in the device tree to ensure the block is enabled.
> Skip if no parent phandle is set in the device tree.
> 
> Signed-off-by: Thor Thayer <tthayer@opensource.altera.com>
> ---
> v2  No change
> v3  Move check into validate_parent_available().
> ---
>  drivers/edac/altera_edac.c |   17 +++++++++++++++++
>  1 file changed, 17 insertions(+)
> 
> diff --git a/drivers/edac/altera_edac.c b/drivers/edac/altera_edac.c
> index 6f5d586..926bcaf 100644
> --- a/drivers/edac/altera_edac.c
> +++ b/drivers/edac/altera_edac.c
> @@ -1125,6 +1125,20 @@ static void altr_edac_a10_irq_handler(struct irq_desc *desc)
>  	chained_irq_exit(chip, desc);
>  }
>  
> +static int validate_parent_available(struct device_node *np)
> +{
> +	struct device_node *parent;
> +
> +	/* Ensure parent device is enabled if parent node exists */
> +	parent = of_parse_phandle(np, "parent", 0);
> +	if (parent && !of_device_is_available(parent)) {
> +		of_node_put(parent);
> +		return -ENODEV;
> +	}
> +	of_node_put(parent);
> +	return 0;
> +}

How about this - it is a bit simpler:

static int validate_parent_available(struct device_node *np)
{
        struct device_node *parent;
        int ret = 0;

        /* Ensure parent device is enabled if parent node exists */
        parent = of_parse_phandle(np, "parent", 0);
        if (parent && !of_device_is_available(parent))
                ret = -ENODEV;

        of_node_put(parent);
        return ret;
}

?

-- 
Regards/Gruss,
    Boris.

ECO tip #101: Trim your mails when you reply.