Re: [PATCH] dt: bindings: Add support for CSI1 bus

[Pavel Machek <pavel@ucw.cz>]

[-- Attachment #1: Type: text/plain, Size: 2471 bytes --]

Hi!

> Thanks for the review.
> 
> On Tue, Jan 03, 2017 at 02:38:54PM -0600, Rob Herring wrote:
> > On Wed, Dec 28, 2016 at 07:30:36PM +0100, Pavel Machek wrote:
> > > From: Sakari Ailus <sakari.ailus@iki.fi>
> > > 
> > > In the vast majority of cases the bus type is known to the driver(s)
> > > since a receiver or transmitter can only support a single one. There
> > > are cases however where different options are possible.
> > 
> > What cases specifically?
> 
> The existing V4L2 OF support tries to figure out the bus type and parse the
> bus parameters based on that. This does not scale too well as there are
> multiple serial busses that share common properties.
> 
> Some hardware also supports multiple types of busses on the same interfaces.

Ok, I'll include that in the changelog.

> > As in MIPI CSI2?
> 
> Yeah, I guess it'd make sense to make this explicit.

Ok.

> > >    should be the combined length of data-lanes and clock-lanes properties.
> > > -  If the lane-polarities property is omitted, the value must be interpreted
> > > -  as 0 (normal). This property is valid for serial busses only.
> > 
> > Why is this removed?
> 
> Must have been by mistake. :-)

Fixed.

> > > -
> > > +- clock-inv: Clock or strobe signal inversion.
> > > +  Possible values: 0 -- not inverted; 1 -- inverted
> > 
> > "invert" assumes I know what is normal and I do not. Define what is 
> > "normal" and name the property the opposite of that. If normal is data 
> > shifted on clock rising edge, then call the the property 
> > "clock-shift-falling-edge" for example..
> 
> The hardware documentation says this is the "strobe/clock inversion control
> signal". I'm not entirely sure whether this is just signal polarity (it's a
> differential signal) or inversion of an internal signal of the CCP2 block.
> 
> It might make sense to make this a private property for the OMAP 3 ISP
> instead. If it's seen elsewhere, then think about it again. I doubt it
> would, as CCP2 is an old bus that's used on Nokia N9, N950 and N900.
> 
> As strobe is included, I'd add that to the name. Say,
> "ti,clock-strobe-inv".

Hmm. N900 does not use inversion. Would it make sense to simply
hardcode it to "not-inverted" for now?

Device tree changes are PITA :-(.
									Pavel

-- 
(english) http://www.livejournal.com/~pavelmachek
(cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html

[-- Attachment #2: Digital signature --]
[-- Type: application/pgp-signature, Size: 181 bytes --]