From: Sakari Ailus <sakari.ailus@linux.intel.com>
To: linux-media@vger.kernel.org
Cc: laurent.pinchart@ideasonboard.com,
Dave Stevenson <dave.stevenson@raspberrypi.com>,
Jacopo Mondi <jacopo.mondi@ideasonboard.com>,
Tomi Valkeinen <tomi.valkeinen@ideasonboard.com>,
Jai Luthra <jai.luthra@ideasonboard.com>,
Mehdi Djait <mehdi.djait@linux.intel.com>,
Frank Li <Frank.li@nxp.com>
Subject: [PATCH v2 09/17] media: bcm2835-unicam: Use v4l2_subdev_get_frame_desc()
Date: Mon, 18 May 2026 19:43:09 +0300 [thread overview]
Message-ID: <20260518164318.3367888-10-sakari.ailus@linux.intel.com> (raw)
In-Reply-To: <20260518164318.3367888-1-sakari.ailus@linux.intel.com>
Call v4l2_subdev_get_frame_desc() to obtain the frame descriptor. This is
preferred over calling the get_frame_desc() pad operation directly.
Signed-off-by: Sakari Ailus <sakari.ailus@linux.intel.com>
---
.../media/platform/broadcom/bcm2835-unicam.c | 22 +++++++++----------
1 file changed, 10 insertions(+), 12 deletions(-)
diff --git a/drivers/media/platform/broadcom/bcm2835-unicam.c b/drivers/media/platform/broadcom/bcm2835-unicam.c
index 8d28ba0b59a3..7e299ebf3470 100644
--- a/drivers/media/platform/broadcom/bcm2835-unicam.c
+++ b/drivers/media/platform/broadcom/bcm2835-unicam.c
@@ -27,6 +27,7 @@
* output interface and V4L2 subdevice driver.
*/
+#include <linux/cleanup.h>
#include <linux/clk.h>
#include <linux/delay.h>
#include <linux/device.h>
@@ -888,7 +889,6 @@ static int unicam_get_image_vc_dt(struct unicam_device *unicam,
struct v4l2_subdev_state *state,
u8 *vc, u8 *dt)
{
- struct v4l2_mbus_frame_desc fd;
u32 stream;
int ret;
@@ -898,17 +898,15 @@ static int unicam_get_image_vc_dt(struct unicam_device *unicam,
if (ret)
return ret;
- ret = v4l2_subdev_call(unicam->sensor.subdev, pad, get_frame_desc,
- unicam->sensor.pad->index, &fd);
- if (ret)
- return ret;
-
- /* Only CSI-2 supports DTs. */
- if (fd.type != V4L2_MBUS_FRAME_DESC_TYPE_CSI2)
- return -EINVAL;
+ struct v4l2_mbus_frame_desc *fd __free(v4l2_subdev_free_frame_desc) =
+ v4l2_subdev_get_frame_desc(unicam->sensor.subdev,
+ unicam->sensor.pad->index,
+ V4L2_MBUS_FRAME_DESC_TYPE_CSI2);
+ if (IS_ERR(fd))
+ return PTR_ERR(fd);
- for (unsigned int i = 0; i < fd.num_entries; ++i) {
- const struct v4l2_mbus_frame_desc_entry *fde = &fd.entry[i];
+ for (unsigned int i = 0; i < fd->num_entries; ++i) {
+ const struct v4l2_mbus_frame_desc_entry *fde = &fd->entry[i];
if (fde->stream == stream) {
*vc = fde->bus.csi2.vc;
@@ -927,7 +925,7 @@ static void unicam_start_rx(struct unicam_device *unicam,
const struct unicam_format_info *fmtinfo;
const struct v4l2_mbus_framefmt *fmt;
unsigned int line_int_freq;
- u8 vc, dt;
+ u8 vc = 0, dt = 0;
u32 val;
int ret;
--
2.47.3
next prev parent reply other threads:[~2026-05-18 16:43 UTC|newest]
Thread overview: 33+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-05-18 16:43 [PATCH v2 00/17] Rework frame descriptors Sakari Ailus
2026-05-18 16:43 ` [PATCH v2 01/17] media: v4l2-common: Add helper function media_bus_fmt_to_csi2_(bpp|dt)() Sakari Ailus
2026-05-18 16:43 ` [PATCH v2 02/17] media: v4l2-subdev: Align frame descriptor error codes with routing Sakari Ailus
2026-05-18 16:43 ` [PATCH v2 03/17] media: v4l2-subdev: Prepare for changes in getting frame descriptors Sakari Ailus
2026-05-18 16:43 ` [PATCH v2 04/17] media: v4l2-subdev: Allow releasing frame descriptors on return Sakari Ailus
2026-05-19 21:34 ` Frank Li
2026-05-20 12:56 ` Sakari Ailus
2026-05-18 16:43 ` [PATCH v2 05/17] media: v4l2-subdev: Allocate frame descriptors based on the need Sakari Ailus
2026-05-19 21:53 ` Frank Li
2026-05-19 22:18 ` Frank Li
2026-05-18 16:43 ` [PATCH v2 06/17] media: v4l2-subdev: Change the maximum number of routes Sakari Ailus
2026-05-19 21:55 ` Frank Li
2026-05-18 16:43 ` [PATCH v2 07/17] media: v4l2-subdev: Return dynamically allocated pass-through routes Sakari Ailus
2026-05-19 22:33 ` Frank Li
2026-05-20 12:59 ` Sakari Ailus
2026-05-18 16:43 ` [PATCH v2 08/17] media: v4l2-subdev: Always return at least one frame descriptor Sakari Ailus
2026-05-19 22:35 ` Frank Li
2026-05-18 16:43 ` Sakari Ailus [this message]
2026-05-18 16:43 ` [PATCH v2 10/17] media: nxp: imx8-isi: Use v4l2_subdev_get_frame_desc() Sakari Ailus
2026-05-19 22:36 ` Frank Li
2026-05-18 16:43 ` [PATCH v2 11/17] media: raspberrypi: cfe: " Sakari Ailus
2026-05-18 16:43 ` [PATCH v2 12/17] media: rzg2l-cru: " Sakari Ailus
2026-05-18 16:43 ` [PATCH v2 13/17] media: rkisp1: " Sakari Ailus
2026-05-18 16:43 ` [PATCH v2 14/17] media: exynos4-is: " Sakari Ailus
2026-05-18 16:43 ` [PATCH v2 15/17] media: ti: cal: " Sakari Ailus
2026-05-18 16:43 ` [PATCH v2 16/17] media: ipu6: " Sakari Ailus
2026-05-18 16:43 ` [PATCH v2 17/17] staging: media: ipu7: " Sakari Ailus
2026-06-11 12:49 ` [PATCH v2 00/17] Rework frame descriptors Tomi Valkeinen
2026-06-12 8:28 ` Sakari Ailus
2026-06-23 7:39 ` Sakari Ailus
2026-08-14 8:17 ` Mattijs Korpershoek
2026-08-14 8:21 ` Tomi Valkeinen
2026-08-14 9:26 ` Mattijs Korpershoek
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20260518164318.3367888-10-sakari.ailus@linux.intel.com \
--to=sakari.ailus@linux.intel.com \
--cc=Frank.li@nxp.com \
--cc=dave.stevenson@raspberrypi.com \
--cc=jacopo.mondi@ideasonboard.com \
--cc=jai.luthra@ideasonboard.com \
--cc=laurent.pinchart@ideasonboard.com \
--cc=linux-media@vger.kernel.org \
--cc=mehdi.djait@linux.intel.com \
--cc=tomi.valkeinen@ideasonboard.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.