[PATCH v5 16/23] dmaengine: ste_dma40: Validate disabled channel indexes

[Linus Walleij <linusw@kernel.org>]

d40_of_probe() checks how many entries disabled-channels contains, but not
the channel numbers themselves. d40_phy_res_init() later uses every value
as an index into base->phy_res, whose size is the number of channels found
in this DMA40 instance. An out-of-range value can therefore write beyond
the allocation.

Validate each disabled channel against the detected hardware channel count
before allocating and initializing the channel resources.

Fixes: 499c2bc3cc89 ("dmaengine: ste_dma40: Fetch disabled channels from DT")
Assisted-by: LLM
Signed-off-by: Linus Walleij <linusw@kernel.org>
---
 drivers/dma/ste_dma40.c | 9 +++++++++
 1 file changed, 9 insertions(+)

diff --git a/drivers/dma/ste_dma40.c b/drivers/dma/ste_dma40.c
index b628f8577e41..b7d228706014 100644
--- a/drivers/dma/ste_dma40.c
+++ b/drivers/dma/ste_dma40.c
@@ -3427,6 +3427,15 @@ static int __init d40_hw_detect_init(struct platform_device *pdev,
 
 	num_phy_chans = min(num_phy_chans, STEDMA40_MAX_PHYS);
 
+	for (i = 0; plat_data->disabled_channels[i] != -1; i++) {
+		int chan = plat_data->disabled_channels[i];
+
+		if (chan < 0 || chan >= num_phy_chans) {
+			dev_err(dev, "Invalid disabled channel %d\n", chan);
+			return -EINVAL;
+		}
+	}
+
 	/* The number of channels used for memcpy */
 	num_memcpy_chans = plat_data->num_of_memcpy_chans;
 	num_log_chans = num_phy_chans * D40_MAX_LOG_CHAN_PER_PHY;

-- 
2.55.0