Re: [PATCH 2/2] sh_eth: remove 'register_type' field from 'struct sh_eth_plat_data'

[Laurent Pinchart <laurent.pinchart@ideasonboard.com>]

Hi Sergei,

Thank you for the patch.

On Sunday 18 August 2013 03:13:26 Sergei Shtylyov wrote:
> Now that the 'register_type' field of the 'sh_eth' driver's platform data is
> not used by the driver anymore, it's time to remove it and  its
> initializers from the SH platform code. Also  move *enum* declaring values
> for this  field from <linux/sh_eth.h>  to  the  local driver's  header file
> as they're only needed by the driver itself  now...
> 
> Signed-off-by: Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>
> 
> ---
>  arch/arm/mach-shmobile/board-armadillo800eva.c |    1 -
>  arch/arm/mach-shmobile/board-bockw.c           |    1 -
>  arch/sh/boards/board-espt.c                    |    1 -
>  arch/sh/boards/board-sh7757lcr.c               |    4 ----
>  arch/sh/boards/mach-ecovec24/setup.c           |    1 -
>  arch/sh/boards/mach-se/7724/setup.c            |    1 -
>  arch/sh/boards/mach-sh7763rdp/setup.c          |    1 -
>  arch/sh/kernel/cpu/sh2/setup-sh7619.c          |    1 -
>  drivers/net/ethernet/renesas/sh_eth.h          |    7 +++++++
>  include/linux/sh_eth.h                         |    7 -------
>  10 files changed, 7 insertions(+), 18 deletions(-)

[snip]

> Index: net-next/drivers/net/ethernet/renesas/sh_eth.h
> =================================> --- net-next.orig/drivers/net/ethernet/renesas/sh_eth.h
> +++ net-next/drivers/net/ethernet/renesas/sh_eth.h
> @@ -157,6 +157,13 @@ enum {
>  	SH_ETH_MAX_REGISTER_OFFSET,
>  };
> 
> +enum {
> +	SH_ETH_REG_GIGABIT,
> +	SH_ETH_REG_FAST_RCAR,
> +	SH_ETH_REG_FAST_SH4,
> +	SH_ETH_REG_FAST_SH3_SH2
> +};
> +

Would it make sense to move this change and the one below to a separate patch 
to be merged through the net tree ?

>  /* Driver's parameters */
>  #if defined(CONFIG_CPU_SH4) || defined(CONFIG_ARCH_SHMOBILE)
>  #define SH4_SKB_RX_ALIGN	32
> Index: net-next/include/linux/sh_eth.h
> =================================> --- net-next.orig/include/linux/sh_eth.h
> +++ net-next/include/linux/sh_eth.h
> @@ -5,17 +5,10 @@
>  #include <linux/if_ether.h>
> 
>  enum {EDMAC_LITTLE_ENDIAN, EDMAC_BIG_ENDIAN};
> -enum {
> -	SH_ETH_REG_GIGABIT,
> -	SH_ETH_REG_FAST_RCAR,
> -	SH_ETH_REG_FAST_SH4,
> -	SH_ETH_REG_FAST_SH3_SH2
> -};
> 
>  struct sh_eth_plat_data {
>  	int phy;
>  	int edmac_endian;

Wouldn't it make sense to move the edmac_endian field to sh_eth_cpu_data as 
well ?

> -	int register_type;
>  	phy_interface_t phy_interface;
>  	void (*set_mdio_gate)(void *addr);

-- 
Regards,

Laurent Pinchart