[LARTC] how to make setting using tc command as permanent.

[LARTC] how to make setting using tc command as permanent.

[Raghuvendra Kumar]

Hi,

I am facing a problem.Suppose i made some QOS configuration using tc.
But if system reboots, it disappears.

How to make tc setting permanent.

Regards,

Raghuvendra Kumar | BTSL
414 | Ext
011-41619770 | Desk
+91-9818143739 | Mobile
raghuvendra.kumar@bhartitelesoft.com | EMail
_______________________________________________
LARTC mailing list
LARTC@mailman.ds9a.nl
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc

Re: [LARTC] how to make setting using tc command as permanent.

[Nikolay Kichukov]

Hello,
You need to call your script on startup. However there are different
methods of doing this.
On a slackware linux you can user /etc/init.d/rc.local
On a debian linux that script also exists so you can use it as well.
Just make sure it is sym-linked to /etc/rc2.d/

HTH,
-Nikolay

Raghuvendra Kumar wrote:
> Hi,
> 
> I am facing a problem.Suppose i made some QOS configuration using tc.
> But if system reboots, it disappears.
> 
> How to make tc setting permanent.
> 
> Regards,
> 
> Raghuvendra Kumar | BTSL
> 414 | Ext
> 011-41619770 | Desk
> +91-9818143739 | Mobile
> raghuvendra.kumar@bhartitelesoft.com | EMail
> _______________________________________________
> LARTC mailing list
> LARTC@mailman.ds9a.nl
> http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc
_______________________________________________
LARTC mailing list
LARTC@mailman.ds9a.nl
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc