From: Konrad Dybcio <konrad.dybcio@linaro.org>
To: Bryan O'Donoghue <bryan.odonoghue@linaro.org>,
rfoss@kernel.org, todor.too@gmail.com, agross@kernel.org,
andersson@kernel.org, mchehab@kernel.org,
hverkuil-cisco@xs4all.nl, laurent.pinchart@ideasonboard.com,
sakari.ailus@linux.intel.com, andrey.konovalov@linaro.org
Cc: linux-media@vger.kernel.org, linux-arm-msm@vger.kernel.org,
linux-kernel@vger.kernel.org
Subject: Re: [PATCH v3 15/15] media: qcom: camss: Comment CSID dt_id field
Date: Sat, 26 Aug 2023 12:18:26 +0200 [thread overview]
Message-ID: <4929aa72-a134-4eeb-850e-46d9255c011b@linaro.org> (raw)
In-Reply-To: <20230823104444.1954663-16-bryan.odonoghue@linaro.org>
On 23.08.2023 12:44, Bryan O'Donoghue wrote:
> Digging into the documentation we find that the DT_ID bitfield is used to
> map the six bit DT to a two bit ID code. This value is concatenated to the
> VC bitfield to create a CID value. DT_ID is the two least significant bits
> of CID and VC the most significant bits.
>
> Originally we set dt_id = vc * 4 in and then subsequently set dt_id = vc.
>
> commit 3c4ed72a16bc ("media: camss: sm8250: Virtual channels for CSID")
> silently fixed the multiplication by four which would give a better
> value for the generated CID without mentioning what was being done or why.
>
> Next up I haplessly changed the value back to "dt_id = vc * 4" since there
> didn't appear to be any logic behind it.
>
> Hans asked what the change was for and I honestly couldn't remember the
> provenance of it, so I dug in.
>
> Link: https://lore.kernel.org/linux-arm-msm/edd4bf9b-0e1b-883c-1a4d-50f4102c3924@xs4all.nl/
>
> Add a comment so the next hapless programmer doesn't make this same
> mistake.
>
> Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org>
> ---
> drivers/media/platform/qcom/camss/camss-csid-gen2.c | 5 +++++
> 1 file changed, 5 insertions(+)
>
> diff --git a/drivers/media/platform/qcom/camss/camss-csid-gen2.c b/drivers/media/platform/qcom/camss/camss-csid-gen2.c
> index 6ba2b10326444..cee50fc87e9de 100644
> --- a/drivers/media/platform/qcom/camss/camss-csid-gen2.c
> +++ b/drivers/media/platform/qcom/camss/camss-csid-gen2.c
> @@ -352,6 +352,11 @@ static void __csid_configure_stream(struct csid_device *csid, u8 enable, u8 vc)
> phy_sel = csid->phy.csiphy_id;
>
> if (enable) {
> + /*
> + * A value caled 'CID' gets generated internal to CAMSS logic
> + * which is a concatenation of [vc:6 | dt_id:2] hence we reuse
> + * the least significant two bits of the VC to 'stuff' the CID value.
> + */
> u8 dt_id = vc;
And where are you discarding the non-2-lsb?
Konrad
next prev parent reply other threads:[~2023-08-26 10:19 UTC|newest]
Thread overview: 63+ messages / expand[flat|nested] mbox.gz Atom feed top
2023-08-23 10:44 [PATCH v3 00/15] media: qcom: camss: Add parameter passing to remove several outstanding bugs Bryan O'Donoghue
2023-08-23 10:44 ` [PATCH v3 01/15] media: qcom: camss: Amalgamate struct resource with struct resource_ispif Bryan O'Donoghue
2023-08-26 9:55 ` Konrad Dybcio
2023-08-28 17:30 ` Laurent Pinchart
2023-08-23 10:44 ` [PATCH v3 02/15] media: qcom: camss: Start to move to module compat matched resources Bryan O'Donoghue
2023-08-28 17:33 ` Laurent Pinchart
2023-08-23 10:44 ` [PATCH v3 03/15] media: qcom: camss: Pass icc bandwidth table as a platform parameter Bryan O'Donoghue
2023-08-28 17:35 ` Laurent Pinchart
2023-08-23 10:44 ` [PATCH v3 04/15] media: qcom: camss: Pass remainder of variables as resources Bryan O'Donoghue
2023-08-26 9:57 ` Konrad Dybcio
2023-08-28 17:51 ` Laurent Pinchart
2023-08-23 10:44 ` [PATCH v3 05/15] media: qcom: camss: Pass line_num from compat resources Bryan O'Donoghue
2023-08-28 18:36 ` Laurent Pinchart
2023-08-28 19:31 ` Bryan O'Donoghue
2023-08-23 10:44 ` [PATCH v3 06/15] media: qcom: camss: Assign the correct number of RDIs per VFE Bryan O'Donoghue
2023-08-28 18:43 ` Laurent Pinchart
2023-08-23 10:44 ` [PATCH v3 07/15] media: qcom: camss: Capture VFE CSID dependency in a helper function Bryan O'Donoghue
2023-08-26 10:02 ` Konrad Dybcio
2023-08-26 12:01 ` Bryan O'Donoghue
2023-08-26 12:04 ` Konrad Dybcio
2023-08-26 12:12 ` Bryan O'Donoghue
2023-08-26 12:13 ` Konrad Dybcio
2023-08-26 12:16 ` Bryan O'Donoghue
2023-08-28 18:47 ` Laurent Pinchart
2023-08-28 19:37 ` Bryan O'Donoghue
2023-08-28 19:40 ` Laurent Pinchart
2023-08-28 19:41 ` Bryan O'Donoghue
2023-09-04 10:15 ` Bryan O'Donoghue
2023-08-23 10:44 ` [PATCH v3 08/15] media: qcom: camss: Untangle if/else spaghetti in camss Bryan O'Donoghue
2023-08-26 10:03 ` Konrad Dybcio
2023-08-28 18:51 ` Laurent Pinchart
2023-08-28 19:43 ` Bryan O'Donoghue
2023-09-04 12:24 ` Bryan O'Donoghue
2023-08-23 10:44 ` [PATCH v3 09/15] media: qcom: camss: Improve error printout on icc_get fail Bryan O'Donoghue
2023-08-26 10:05 ` Konrad Dybcio
2023-08-26 12:01 ` Bryan O'Donoghue
2023-08-23 10:44 ` [PATCH v3 10/15] media: qcom: camss: Allow clocks vfeN vfe_liteN or vfe_lite Bryan O'Donoghue
2023-08-26 10:08 ` Konrad Dybcio
2023-08-26 12:05 ` Bryan O'Donoghue
2023-08-28 18:55 ` Laurent Pinchart
2023-08-23 10:44 ` [PATCH v3 11/15] media: qcom: camss: Functionally decompose CSIPHY clock lookups Bryan O'Donoghue
2023-08-26 10:12 ` Konrad Dybcio
2023-08-26 12:07 ` Bryan O'Donoghue
2023-08-26 12:11 ` Konrad Dybcio
2023-08-26 12:14 ` Bryan O'Donoghue
2023-08-26 12:48 ` Konrad Dybcio
2023-08-28 18:59 ` Laurent Pinchart
2023-08-23 10:44 ` [PATCH v3 12/15] media: qcom: camss: Fix support for setting CSIPHY clock name csiphyX Bryan O'Donoghue
2023-08-26 10:13 ` Konrad Dybcio
2023-08-26 12:08 ` Bryan O'Donoghue
2023-08-26 12:12 ` Konrad Dybcio
2023-09-04 19:11 ` Bryan O'Donoghue
2023-09-04 19:32 ` Konrad Dybcio
2023-09-04 19:33 ` Bryan O'Donoghue
2023-08-23 10:44 ` [PATCH v3 13/15] media: qcom: camss: Support RDI3 for VFE 17x Bryan O'Donoghue
2023-08-28 19:03 ` Laurent Pinchart
2023-08-23 10:44 ` [PATCH v3 14/15] media: qcom: camss: Convert vfe_disable() from int to void Bryan O'Donoghue
2023-08-26 10:16 ` Konrad Dybcio
2023-08-23 10:44 ` [PATCH v3 15/15] media: qcom: camss: Comment CSID dt_id field Bryan O'Donoghue
2023-08-26 10:18 ` Konrad Dybcio [this message]
2023-08-28 15:34 ` Bryan O'Donoghue
2023-08-28 15:38 ` Konrad Dybcio
2023-08-28 15:43 ` Bryan O'Donoghue
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=4929aa72-a134-4eeb-850e-46d9255c011b@linaro.org \
--to=konrad.dybcio@linaro.org \
--cc=agross@kernel.org \
--cc=andersson@kernel.org \
--cc=andrey.konovalov@linaro.org \
--cc=bryan.odonoghue@linaro.org \
--cc=hverkuil-cisco@xs4all.nl \
--cc=laurent.pinchart@ideasonboard.com \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-media@vger.kernel.org \
--cc=mchehab@kernel.org \
--cc=rfoss@kernel.org \
--cc=sakari.ailus@linux.intel.com \
--cc=todor.too@gmail.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.