[lm-sensors] Sensors on an ECS A535 laptop

[lm-sensors] Sensors on an ECS A535 laptop

[Jon Sturm]

I have an ECS A535 Laptop and I am trying to figure out how if at all I 
can get some support for my sensors, currently sensors detect finds
Driver `it87':
  * ISA bus, address 0x290
    Chip `ITE IT8705F Super IO Sensors' (confidence: 9)

But upon running sensors I get mostly garbage output

in0:         +0.00 V  (min =  +0.00 V, max =  +4.08 V)   ALARM
in1:         +0.00 V  (min =  +0.00 V, max =  +4.08 V)   ALARM
in2:         +0.00 V  (min =  +0.00 V, max =  +4.08 V)   ALARM
in3:         +0.00 V  (min =  +0.00 V, max =  +4.08 V)   ALARM
in4:         +0.00 V  (min =  +0.00 V, max =  +4.08 V)   ALARM
in5:         +0.00 V  (min =  +0.00 V, max =  +4.08 V)   ALARM
in6:         +0.00 V  (min =  +0.00 V, max =  +4.08 V)   ALARM
+5V:         +0.03 V  (min =  +0.00 V, max =  +4.08 V)  
Vbat:        +4.08 V
fan1:          0 RPM  (min =    0 RPM)
Fan2:          0 RPM  (min =    0 RPM)
fan3:          0 RPM  (min =    0 RPM)
M/B Temp:    +68.0°C  (low  = +127.0°C, high = +85.0°C)  sensor = 
thermal diode
CPU Temp:    +67.0°C  (low  =  -1.0°C, high = +127.0°C)  sensor = thermistor
temp3:      -128.0°C  (low  =  -1.0°C, high = +127.0°C)  sensor = disabled

If I run pwmconfig my fan does spin up but as sensors does not show any 
fan speeds it just informs me that it can't do anything and exits. Under 
windows I am able to view one of the fan's speed using speedfan and the 
fan_div is detected as being 128. The Bios tells me nothing when it 
comes to system temps so I was hoping someone would be able to at least 
point me in the right direction.



_______________________________________________
lm-sensors mailing list
lm-sensors@lm-sensors.org
http://lists.lm-sensors.org/mailman/listinfo/lm-sensors