Re: tg3: link is permanently down after ifdown and ifup

[Felix Radensky <felix@embedded-sol.com>]

Hi,

The problem goes away if I remove the call to

tg3_set_power_state(tp, PCI_D3hot);

from tg3_close().

Some relevant stuff from dmesg:

pci 0002:05:00.0: PME# supported from D3hot D3cold
pci 0002:05:00.0: PME# disabled
tg3.c:v3.102 (September 1, 2009)
tg3 0002:05:00.0: enabling device (0000 -> 0002)
tg3 0002:05:00.0: PME# disabled
tg3 mdio bus: probed
eth2: Tigon3 [partno(BCM57760) rev 57780001] (PCI Express) MAC address 
00:10:18:00:00:00
eth2: attached PHY driver [Broadcom BCM57780] (mii_bus:phy_addr=500:01)
eth2: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] TSOcap[1]
eth2: dma_rwctrl[76180000] dma_mask[64-bit]

Is my problem related to hardware or it's a tg3 driver bug ?

Thanks a lot.

Felix.

Felix Radensky wrote:
> Hi,
>
> I have a problem with tg3 driver on a custom MPC8536 based board
> running linux-2.6.31, with tg3 and Broadcom phy drivers taken from
> linux-2.6.32-rc7. Broadcom NIC is BCM57760, phy is BCM57780.
>
> The problem I'm seeing is that the downing and interface leads to
> permanent link loss, even after interface is upped again. E.g, to
> reproduce the problem it is sufficient to run:
>
> modprobe tg3
> ifconfig eth2 up
> ifconfig eth2 down
> ifconfig eth2 up
>
> After ifdown PHY LEDs also go down and do not come back
> after ifup. Ethtool reports that no link is detected. After reloading
> the driver the link comes back.
>
> Am I the only one seeing this problem  ?
> Any help on fixing this is appreciated.
>
> Thanks a lot.
>
> Felix.
>
> _______________________________________________
> Linuxppc-dev mailing list
> Linuxppc-dev@lists.ozlabs.org
> https://lists.ozlabs.org/listinfo/linuxppc-dev