From: Reinhard Meyer <u-boot@emk-elektronik.de>
To: u-boot@lists.denx.de
Subject: [U-Boot] ARM relocation, probably trivial mistake
Date: Thu, 30 Sep 2010 16:20:50 +0200 [thread overview]
Message-ID: <4CA49CC2.2030904@emk-elektronik.de> (raw)
In-Reply-To: <4CA499D5.7060501@denx.de>
Dear Stefano Babic,
>> 1. should CONFIG_SKIP_RELOCATE_UBOOT be not defined anymore?
>
> I had the same issue because I forget to remove it from my config file.
> After dropping it, I got the u-boot prompt again ;-)
Thank you, that (partially) helped:
U-Boot 2010.09-00106-g6e135b9-dirty (Sep 30 2010 - 17:32:36)
U-Boot code: 21F00000 -> 21F3C180 BSS: -> 21F7D700
CPU: AT91SAM9XE
Crystal frequency: 18.432 MHz
CPU clock : 198.656 MHz
Master clock : 99.328 MHz
I2C: ready
monitor len: 0007D700
ramsize: 04000000
Top of RAM usable for U-Boot at: 24000000
Reserving 501k for U-Boot at: 23f82000
Reserving 143k for malloc() at: 23f5e100
Reserving 24 Bytes for Board Info at: 23f5e0e8
Reserving 88 Bytes for Global Data at: 23f5e090
New Stack Pointer is: 23f5e088
RAM Configuration:
Bank #0: 20000000 64 MiB
relocation Offset is: 02082000
monitor flash len: 0003C180
Now running in RAM - U-Boot at: 23f82000
FLASH: 512 KiB
NAND: raise: Signal # 8 caught
raise: Signal # 8 caught
raise: Signal # 8 caught
256 MiB
*** Warning - bad CRC, using default environment
In: serial
Out: serial
Err: serial
MMC: mci: 0
Net: macb0, enc1.0, enc1.1, enc1.2
Reset Ethernet PHY
macb0: Starting autonegotiation...
macb0: Autonegotiation timed out (status=0x7849)
macb0: link down (status: 0x7849)
enc1.0: timeout waiting for CLKRDY
enc1.1: timeout waiting for CLKRDY
enc1.2: timeout waiting for CLKRDY
Press SPACE to abort autoboot in 1 seconds
Before the relocation: macb, enc and environment did work :)
I have to look into that issue later...
Best Regards,
Reinhard
next prev parent reply other threads:[~2010-09-30 14:20 UTC|newest]
Thread overview: 113+ messages / expand[flat|nested] mbox.gz Atom feed top
2010-09-30 13:57 [U-Boot] ARM relocation, probably trivial mistake Reinhard Meyer
2010-09-30 14:08 ` Stefano Babic
2010-09-30 14:20 ` Reinhard Meyer [this message]
2010-09-30 15:39 ` Heiko Schocher
2010-09-30 16:06 ` Reinhard Meyer
2010-09-30 15:38 ` Heiko Schocher
2010-09-30 17:43 ` Wolfgang Denk
2010-10-01 5:25 ` Heiko Schocher
2010-10-01 5:40 ` Albert ARIBAUD
2010-10-01 5:53 ` Heiko Schocher
2010-10-01 6:39 ` Reinhard Meyer
2010-10-01 6:57 ` Heiko Schocher
2010-10-01 8:45 ` Wolfgang Denk
2010-10-01 7:01 ` Albert ARIBAUD
2010-10-01 7:42 ` [U-Boot] ARM relocation, probably trivial mistake - back to original problem Reinhard Meyer
2010-10-01 8:27 ` Heiko Schocher
2010-10-01 10:44 ` Reinhard Meyer
2010-10-01 10:55 ` Wolfgang Denk
2010-10-01 11:03 ` Reinhard Meyer
2010-10-01 11:21 ` Wolfgang Denk
2010-10-01 11:37 ` Reinhard Meyer
2010-10-01 11:59 ` Wolfgang Denk
2010-10-01 12:22 ` Reinhard Meyer
2010-10-01 12:47 ` Reinhard Meyer
2010-10-01 12:55 ` Wolfgang Denk
2010-10-01 14:55 ` Reinhard Meyer
2010-10-02 8:53 ` Heiko Schocher
2010-10-01 15:47 ` Steve Sakoman
2010-10-02 7:15 ` [U-Boot] ARM relocation, question to Heiko Reinhard Meyer
[not found] ` <4CA6E517.9040701@fr<1286167382.22760.19.camel@ptyser-laptop>
2010-10-02 7:53 ` Albert ARIBAUD
2010-10-02 8:10 ` Reinhard Meyer
2010-10-02 8:26 ` Albert ARIBAUD
2010-10-03 18:04 ` Wolfgang Denk
2010-10-02 9:08 ` Heiko Schocher
2010-10-02 9:29 ` Albert ARIBAUD
2010-10-03 18:05 ` Wolfgang Denk
2010-10-02 10:17 ` Joakim Tjernlund
2010-10-02 16:21 ` J. William Campbell
2010-10-02 18:33 ` Reinhard Meyer
2010-10-03 18:22 ` Wolfgang Denk
2010-10-02 20:39 ` Reinhard Meyer
2010-10-02 21:09 ` Albert ARIBAUD
2010-10-02 23:07 ` Graeme Russ
2010-10-03 7:10 ` Albert ARIBAUD
2010-10-03 8:44 ` Graeme Russ
2010-10-03 8:58 ` Albert ARIBAUD
2010-10-03 15:36 ` J. William Campbell
2010-10-03 16:47 ` Albert ARIBAUD
2010-10-03 17:54 ` Albert ARIBAUD
2010-10-03 18:43 ` Wolfgang Denk
2010-10-04 5:41 ` Heiko Schocher
2010-10-03 18:29 ` Wolfgang Denk
2010-10-03 19:26 ` J. William Campbell
2010-10-04 5:52 ` Heiko Schocher
2010-10-03 18:14 ` Wolfgang Denk
2010-10-03 18:54 ` J. William Campbell
2010-10-03 19:52 ` Albert ARIBAUD
2010-10-03 18:03 ` Wolfgang Denk
2010-10-03 18:34 ` Albert ARIBAUD
2010-10-03 18:45 ` Wolfgang Denk
2010-10-04 6:08 ` Heiko Schocher
2010-10-04 6:40 ` Albert ARIBAUD
2010-10-04 7:27 ` Reinhard Meyer
2010-10-04 8:28 ` Albert ARIBAUD
2010-10-04 8:57 ` Heiko Schocher
2010-10-04 9:27 ` Albert ARIBAUD
2010-10-04 10:01 ` Joakim Tjernlund
2010-10-04 9:58 ` Graeme Russ
2010-10-04 14:17 ` Albert ARIBAUD
2010-10-04 14:25 ` Rogan Dawes
2010-10-04 15:24 ` Albert ARIBAUD
2010-10-04 16:31 ` Stefan Roese
2010-10-04 21:31 ` Albert ARIBAUD
2010-10-04 7:44 ` Albert ARIBAUD
2010-10-04 4:43 ` Peter Tyser
2010-10-04 6:08 ` Wolfgang Denk
2010-10-04 7:36 ` Joakim Tjernlund
2010-10-04 8:08 ` Albert ARIBAUD
2010-10-04 8:28 ` Joakim Tjernlund
2010-10-04 8:33 ` Albert ARIBAUD
[not found] ` <OF05779DA1.EF3C4954-ONC12577B2.00307A0D-C12577B2.0030B9C0@tran <4CAA1613.80002@comcast.net>
2010-10-04 8:52 ` Joakim Tjernlund
2010-10-04 9:10 ` Albert ARIBAUD
2010-10-04 10:13 ` Wolfgang Denk
2010-10-04 15:28 ` J. William Campbell
2010-10-04 15:52 ` Albert ARIBAUD
2010-10-04 17:06 ` Wolfgang Denk
2010-10-04 17:59 ` J. William Campbell
2010-10-04 18:43 ` Joakim Tjernlund
2010-10-04 21:10 ` Wolfgang Denk
2010-10-05 7:26 ` Joakim Tjernlund
2010-10-04 17:04 ` Graeme Russ
2010-10-04 17:14 ` Wolfgang Denk
2010-10-04 8:27 ` Wolfgang Denk
2010-10-02 8:49 ` [U-Boot] ARM relocation, probably trivial mistake - back to original problem Heiko Schocher
2010-10-01 12:49 ` Wolfgang Denk
2010-10-01 14:48 ` Reinhard Meyer
2010-10-04 7:44 ` [U-Boot] AT91 clock and timer cleanups (was: ARM relocation, probably trivial mistake - back to original problem) Reinhard Meyer
2010-10-04 8:32 ` Wolfgang Denk
2010-10-04 8:42 ` [U-Boot] AT91 clock and timer cleanups Reinhard Meyer
2010-10-04 8:49 ` Wolfgang Denk
2010-10-04 8:52 ` Reinhard Meyer
2010-10-04 9:03 ` Wolfgang Denk
2010-10-04 9:12 ` Reinhard Meyer
2010-10-04 14:58 ` Reinhard Meyer
2010-10-04 17:00 ` Wolfgang Denk
2010-10-04 17:15 ` Reinhard Meyer
2010-10-04 17:32 ` Wolfgang Denk
2010-10-04 19:22 ` Reinhard Meyer
2010-10-01 8:48 ` [U-Boot] ARM relocation, probably trivial mistake - back to original problem Wolfgang Denk
2010-10-01 9:50 ` Reinhard Meyer
2010-10-01 8:03 ` [U-Boot] ARM relocation, probably trivial mistake Wolfgang Denk
2010-10-01 7:51 ` Wolfgang Denk
2010-10-01 8:28 ` Heiko Schocher
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=4CA49CC2.2030904@emk-elektronik.de \
--to=u-boot@emk-elektronik.de \
--cc=u-boot@lists.denx.de \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.