Re: [Lxc-users] Bad checksums and lost packets with macvlan on dummy

[Daniel Lezcano <daniel.lezcano@free.fr>]

On 03/01/2011 05:51 PM, Patrick McHardy wrote:
> On 01.03.2011 14:29, Daniel Lezcano wrote:
>> On 02/28/2011 08:45 AM, Eric Dumazet wrote:
>>>> In the normal case, dummy0 is supposed to drop the packets. But with
>>>> macvlan these packets are broadcasted to the other macvlan ports, so no
>>>> checksum is computed when the packets are transmitted between macvlan1
>>>> and macvlan2.
>>> So where frames get bad checksums ?
>>>
>>> In this "bridge" mode, I suspect the broadcast is done _before_ sending
>>> frame to dummy, so maybe macvlan should not inherit from lowerdev in
>>> this particular case ?
>> Hi Eric,
>>
>> yes, you are right, the packets are sent before.
>>
>> In the 'macvlan_queue_xmit', the code checks the dev is in 'bridge'
>> mode. If so, it looks if there is a destination port for the packet and
>> then calls the 'forward' callback which is 'dev_forward_skb'.
>>
>> I was able to reproduce the same problem with qemu and an emulated
>> 'e1000' card instead of dummy0. The packets are dropped too.
>>
>> Patrick, do you have any suggestions to fix this ?
> Since the frames are only looped back locally, I suppose the easiest
> fix would be to mark them with CHECKSUM_UNNECESSARY. Alternatively
> we need to complete the checksum manually, similar to what
> dev_hard_start_xmit() does.

That sounds very simple to fix, maybe too much simple :)

I did the following change:

---
  drivers/net/macvlan.c |    1 +
  1 file changed, 1 insertion(+)

Index: linux-next/drivers/net/macvlan.c
===================================================================
--- linux-next.orig/drivers/net/macvlan.c
+++ linux-next/drivers/net/macvlan.c
@@ -222,6 +222,7 @@ static int macvlan_queue_xmit(struct sk_

         if (vlan->mode == MACVLAN_MODE_BRIDGE) {
                 const struct ethhdr *eth = (void *)skb->data;
+               skb->ip_summed = CHECKSUM_UNNECESSARY;

                 /* send to other bridge ports directly */
                 if (is_multicast_ether_addr(eth->h_dest)) {


and that fixed the problem. Do you think it is acceptable ?

Thanks

   -- Daniel