Re: [Lxc-users] Bad checksums and lost packets with macvlan on dummy

[Patrick McHardy <kaber@trash.net>]

Am 01.03.2011 21:04, schrieb Daniel Lezcano:
> On 03/01/2011 05:51 PM, Patrick McHardy wrote:
>>> Patrick, do you have any suggestions to fix this ?
>> Since the frames are only looped back locally, I suppose the easiest
>> fix would be to mark them with CHECKSUM_UNNECESSARY. Alternatively
>> we need to complete the checksum manually, similar to what
>> dev_hard_start_xmit() does.
> 
> That sounds very simple to fix, maybe too much simple :)
> 
> I did the following change:
> 
> --- linux-next.orig/drivers/net/macvlan.c
> +++ linux-next/drivers/net/macvlan.c
> @@ -222,6 +222,7 @@ static int macvlan_queue_xmit(struct sk_
> 
>         if (vlan->mode == MACVLAN_MODE_BRIDGE) {
>                 const struct ethhdr *eth = (void *)skb->data;
> +               skb->ip_summed = CHECKSUM_UNNECESSARY;
> 
>                 /* send to other bridge ports directly */
>                 if (is_multicast_ether_addr(eth->h_dest)) {
> 
> 
> and that fixed the problem. Do you think it is acceptable ?

The only problem I see is if the packets are bridged to a
different networking device (or redirected using the mirred
action), in this case the checksum will not be completed.
This would be a very strange setup though and probably wouldn't
be using dummy as lower device, so I'm not sure we have to
worry about this case.