Re: [Lxc-users] Bad checksums and lost packets with macvlan on dummy

[Daniel Lezcano <daniel.lezcano@free.fr>]

On 03/02/2011 12:03 PM, Patrick McHardy wrote:
> Am 01.03.2011 21:04, schrieb Daniel Lezcano:
>> On 03/01/2011 05:51 PM, Patrick McHardy wrote:
>>>> Patrick, do you have any suggestions to fix this ?
>>> Since the frames are only looped back locally, I suppose the easiest
>>> fix would be to mark them with CHECKSUM_UNNECESSARY. Alternatively
>>> we need to complete the checksum manually, similar to what
>>> dev_hard_start_xmit() does.
>> That sounds very simple to fix, maybe too much simple :)
>>
>> I did the following change:
>>
>> --- linux-next.orig/drivers/net/macvlan.c
>> +++ linux-next/drivers/net/macvlan.c
>> @@ -222,6 +222,7 @@ static int macvlan_queue_xmit(struct sk_
>>
>>          if (vlan->mode == MACVLAN_MODE_BRIDGE) {
>>                  const struct ethhdr *eth = (void *)skb->data;
>> +               skb->ip_summed = CHECKSUM_UNNECESSARY;
>>
>>                  /* send to other bridge ports directly */
>>                  if (is_multicast_ether_addr(eth->h_dest)) {
>>
>>
>> and that fixed the problem. Do you think it is acceptable ?
> The only problem I see is if the packets are bridged to a
> different networking device (or redirected using the mirred
> action), in this case the checksum will not be completed.
> This would be a very strange setup though and probably wouldn't
> be using dummy as lower device, so I'm not sure we have to
> worry about this case.

I am not sure to get it, do you say the patch is correct ?

If my understanding is correct, the packet will be flagged 
CHECKSUM_UNNECESSARY only for the macvlan devices, right ?

By the way, this problem occurs for any lower device with offloading 
capabilities with a macvlan port in bridge mode.

Thanks
   -- Daniel






<javascript:void(0);>