Re: BLE - multiple connections

[Ajay KV <ajay.kv@globaledgesoft.com>]

On 08/22/2012 11:13 AM, Vinicius Costa Gomes wrote:
> Hi,
>
> On 12:07 Wed 22 Aug, Ajay KV wrote:
>> On 08/17/2012 12:27 PM, Anderson Lizardo wrote:
>>> Hi Ajay
>>>
>>> [your emails to BlueZ mailing list may be getting blocked because you
>>> are using HTML. Please fix that on your mail client. Also remember to
>>> not top-post]
>>>
>>> On Fri, Aug 17, 2012 at 7:34 PM, Ajay KV<ajay.kv@globaledgesoft.com>   wrote:
>>>> Thanks for your reply.  i have 2 dongles of different made  (iogear and
>>>> chirago)  . "Hciconfig hci0 lestates" gives  this following result
>>>>
>>>>     Supported link layer states:
>>>> [...]
>>>>
>>>>              Here my issue is to  know whether (connected mode + advertising
>>>> mode)  is possible at a time . Once A is connected to B (initiator),  i
>>>> could not able to enable advertise in  A  (getting command disallowed ) , so
>>>> that  device C is not getting the connectable advertising packets on
>>>> scanning.
>>> I could not see any reason to get "command disallowed" when enabling
>>> LE adv. Did you try changing dongle combinations to make sure it is
>>> not some hardware issue?
>>>
>>> Regards,
>>
>> Hi,
>>          i could not able to figure it out  yet , why its  showing
>> this error " command disallowed" . Here im using fedora 13 with
>> kernel 2.6.39 . i tried with both dongles , iogear and cirago . But
>> the result is same.  i dont think that  its something wrong with
>> kernel version, as we  uses hci commands (hciconfig hci0 leadv )
>> that directly talks with controller . please clear this issue..
>
> Most probably the controller is in the page scan or inquiry scan state.
> Try doing 'hciconfig hci0 noscan', before enabling advertising.
>

> Cheers,


Hi,
	Still not working  , getting the same old error. i just want to know , 
whether my dual-mode dongle allows this operation or not (Advertising 
mode+ connected mode)		

Regards,