All of lore.kernel.org
 help / color / mirror / Atom feed
From: Sergei Shtylyov <sergei.shtylyov-M4DtvfQ/ZS1MRgGoP+s0PdBPR1lH4CV8@public.gmane.org>
To: Tuomas Tynkkynen <ttynkkynen-DDmLM1+adcrQT0dZR+AlfA@public.gmane.org>
Cc: swarren-3lzwWm7+Weoh9ZMKESR00Q@public.gmane.org,
	linux-tegra-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
	linux-kernel-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
	linux-usb-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
	Mikko Perttunen
	<mperttunen-DDmLM1+adcrQT0dZR+AlfA@public.gmane.org>
Subject: Re: [PATCH 2/2] ARM: dts: USB for Tegra114 Dalmore
Date: Wed, 31 Jul 2013 22:18:55 +0400	[thread overview]
Message-ID: <51F9550F.3080503@cogentembedded.com> (raw)
In-Reply-To: <1375292543-7896-3-git-send-email-ttynkkynen-DDmLM1+adcrQT0dZR+AlfA@public.gmane.org>

Hello.

On 07/31/2013 09:42 PM, Tuomas Tynkkynen wrote:

> From: Mikko Perttunen <mperttunen-DDmLM1+adcrQT0dZR+AlfA@public.gmane.org>

> Device tree entries for the three EHCI controllers on Tegra114.
> Enables the the third controller (USB host) on Dalmore.

    I would have done the board patch separately from the SoC one.

> Signed-off-by: Mikko Perttunen <mperttunen-DDmLM1+adcrQT0dZR+AlfA@public.gmane.org>
[...]

> diff --git a/arch/arm/boot/dts/tegra114.dtsi b/arch/arm/boot/dts/tegra114.dtsi
> index abf6c40..2905145 100644
> --- a/arch/arm/boot/dts/tegra114.dtsi
> +++ b/arch/arm/boot/dts/tegra114.dtsi
> @@ -430,6 +430,68 @@
>   		status = "disable";
>   	};
>
> +	usb@7d000000 {
> +		compatible = "nvidia,tegra30-ehci", "usb-ehci";
> +		reg = <0x7d000000 0x4000>;
> +		interrupts = <GIC_SPI 20 IRQ_TYPE_LEVEL_HIGH>;
> +		phy_type = "utmi";
> +		clocks = <&tegra_car TEGRA114_CLK_USBD>;
> +		nvidia,phy = <&phy1>;
> +		status = "disabled";
> +	};
> +
> +	phy1: usb-phy@7d000000 {

    At the same address as the previous node?

> +		compatible = "nvidia,tegra30-usb-phy";
> +		reg = <0x7d000000 0x4000 0x7d000000 0x4000>;

    Hm, there must be some mistake: two similar register ranges.

> +	usb@7d008000 {
> +		compatible = "nvidia,tegra30-ehci", "usb-ehci";
> +		reg = <0x7d008000 0x4000>;
> +		interrupts = <GIC_SPI 97 IRQ_TYPE_LEVEL_HIGH>;
> +		phy_type = "utmi";
> +		clocks = <&tegra_car TEGRA114_CLK_USB3>;
> +		nvidia,phy = <&phy3>;
> +		status = "disabled";
> +	};
> +
> +	phy3: usb-phy@7d008000 {

    Again at the same address as previous node?

> +		compatible = "nvidia,tegra30-usb-phy";
> +		reg = <0x7d008000 0x4000 0x7d000000 0x4000>;

    Second range conflicts with previous nodes.

WBR, Sergei

--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html

WARNING: multiple messages have this Message-ID (diff)
From: Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>
To: Tuomas Tynkkynen <ttynkkynen@nvidia.com>
Cc: swarren@wwwdotorg.org, linux-tegra@vger.kernel.org,
	linux-kernel@vger.kernel.org, linux-usb@vger.kernel.org,
	Mikko Perttunen <mperttunen@nvidia.com>
Subject: Re: [PATCH 2/2] ARM: dts: USB for Tegra114 Dalmore
Date: Wed, 31 Jul 2013 22:18:55 +0400	[thread overview]
Message-ID: <51F9550F.3080503@cogentembedded.com> (raw)
In-Reply-To: <1375292543-7896-3-git-send-email-ttynkkynen@nvidia.com>

Hello.

On 07/31/2013 09:42 PM, Tuomas Tynkkynen wrote:

> From: Mikko Perttunen <mperttunen@nvidia.com>

> Device tree entries for the three EHCI controllers on Tegra114.
> Enables the the third controller (USB host) on Dalmore.

    I would have done the board patch separately from the SoC one.

> Signed-off-by: Mikko Perttunen <mperttunen@nvidia.com>
[...]

> diff --git a/arch/arm/boot/dts/tegra114.dtsi b/arch/arm/boot/dts/tegra114.dtsi
> index abf6c40..2905145 100644
> --- a/arch/arm/boot/dts/tegra114.dtsi
> +++ b/arch/arm/boot/dts/tegra114.dtsi
> @@ -430,6 +430,68 @@
>   		status = "disable";
>   	};
>
> +	usb@7d000000 {
> +		compatible = "nvidia,tegra30-ehci", "usb-ehci";
> +		reg = <0x7d000000 0x4000>;
> +		interrupts = <GIC_SPI 20 IRQ_TYPE_LEVEL_HIGH>;
> +		phy_type = "utmi";
> +		clocks = <&tegra_car TEGRA114_CLK_USBD>;
> +		nvidia,phy = <&phy1>;
> +		status = "disabled";
> +	};
> +
> +	phy1: usb-phy@7d000000 {

    At the same address as the previous node?

> +		compatible = "nvidia,tegra30-usb-phy";
> +		reg = <0x7d000000 0x4000 0x7d000000 0x4000>;

    Hm, there must be some mistake: two similar register ranges.

> +	usb@7d008000 {
> +		compatible = "nvidia,tegra30-ehci", "usb-ehci";
> +		reg = <0x7d008000 0x4000>;
> +		interrupts = <GIC_SPI 97 IRQ_TYPE_LEVEL_HIGH>;
> +		phy_type = "utmi";
> +		clocks = <&tegra_car TEGRA114_CLK_USB3>;
> +		nvidia,phy = <&phy3>;
> +		status = "disabled";
> +	};
> +
> +	phy3: usb-phy@7d008000 {

    Again at the same address as previous node?

> +		compatible = "nvidia,tegra30-usb-phy";
> +		reg = <0x7d008000 0x4000 0x7d000000 0x4000>;

    Second range conflicts with previous nodes.

WBR, Sergei


  parent reply	other threads:[~2013-07-31 18:18 UTC|newest]

Thread overview: 25+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2013-07-31 17:42 [PATCH 0/2] Device tree changes for Tegra30 and Tegra114 USB Host support Tuomas Tynkkynen
2013-07-31 17:42 ` Tuomas Tynkkynen
2013-07-31 17:42 ` [PATCH 1/2] ARM: DTS: tegra: Add USB entries for Tegra30 Tuomas Tynkkynen
2013-07-31 17:42   ` Tuomas Tynkkynen
     [not found]   ` <1375292543-7896-2-git-send-email-ttynkkynen-DDmLM1+adcrQT0dZR+AlfA@public.gmane.org>
2013-07-31 22:13     ` Stephen Warren
2013-07-31 22:13       ` Stephen Warren
     [not found]       ` <51F98C27.40904-3lzwWm7+Weoh9ZMKESR00Q@public.gmane.org>
2013-08-01 15:15         ` Tuomas Tynkkynen
2013-08-01 15:15           ` Tuomas Tynkkynen
2013-07-31 17:42 ` [PATCH 2/2] ARM: dts: USB for Tegra114 Dalmore Tuomas Tynkkynen
2013-07-31 17:42   ` Tuomas Tynkkynen
     [not found]   ` <1375292543-7896-3-git-send-email-ttynkkynen-DDmLM1+adcrQT0dZR+AlfA@public.gmane.org>
2013-07-31 18:18     ` Sergei Shtylyov [this message]
2013-07-31 18:18       ` Sergei Shtylyov
2013-07-31 19:31       ` Tuomas Tynkkynen
     [not found]         ` <51F9660C.6090604-X3B1VOXEql0@public.gmane.org>
2013-07-31 19:53           ` Sergei Shtylyov
2013-07-31 19:53             ` Sergei Shtylyov
     [not found]             ` <51F96B48.10209-M4DtvfQ/ZS1MRgGoP+s0PdBPR1lH4CV8@public.gmane.org>
2013-07-31 22:06               ` Stephen Warren
2013-07-31 22:06                 ` Stephen Warren
     [not found]                 ` <51F98A78.9060309-3lzwWm7+Weoh9ZMKESR00Q@public.gmane.org>
2013-07-31 22:20                   ` Sergei Shtylyov
2013-07-31 22:20                     ` Sergei Shtylyov
     [not found]                     ` <51F98D92.3010607-M4DtvfQ/ZS1MRgGoP+s0PdBPR1lH4CV8@public.gmane.org>
2013-07-31 23:29                       ` Stephen Warren
2013-07-31 23:29                         ` Stephen Warren
     [not found]                         ` <51F99DE4.7010503-3lzwWm7+Weoh9ZMKESR00Q@public.gmane.org>
2013-08-01 12:37                           ` Sergei Shtylyov
2013-08-01 12:37                             ` Sergei Shtylyov
2013-08-15 10:54                           ` Thierry Reding
2013-08-15 10:54                             ` Thierry Reding

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=51F9550F.3080503@cogentembedded.com \
    --to=sergei.shtylyov-m4dtvfq/zs1mrggop+s0pdbpr1lh4cv8@public.gmane.org \
    --cc=linux-kernel-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
    --cc=linux-tegra-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
    --cc=linux-usb-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
    --cc=mperttunen-DDmLM1+adcrQT0dZR+AlfA@public.gmane.org \
    --cc=swarren-3lzwWm7+Weoh9ZMKESR00Q@public.gmane.org \
    --cc=ttynkkynen-DDmLM1+adcrQT0dZR+AlfA@public.gmane.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.