Re: [patch net-next RFC 0/4] introduce infrastructure for support of switch chip datapath

[Jamal Hadi Salim <jhs@mojatatu.com>]

On 03/26/14 03:21, Jiri Pirko wrote:

>
> Creating bonding of the switch ports does not fit into the picture at
> all. These port netdevices are just a representation of a port. Not
> actual netdevice where the data goes through.
>
> Please consider the case I gave already to this thread:
>
>          switch chip
>     ------------------------
>      |  |  |  |  |  |   |               CPU
>     p1 p2 ...pn px py  MNGMNT       -----------
>                  |  |   |              pcie
>                  |  |   |         ---------------
>                  |  |   |          |  NIC0 NIC1
>                  |  |   ---pcie-----   |   |
>                  |  ------someMII-------   |
>                  ---------someMII-----------
>
>          NIC0 and NIC1 are ordinary NICs like 8139too for example with no
>          notion they are connected to a switch. They as completely
>          independent on the mngmnt iface.
>
 > There, actual data is coming through NIC0 and NIC1 which is
 > completely separated
 > from the p1...pn,px.px port representations.
 >
 > And if you understand it this way, it makes perfect sense to have a
 > master device
 > for these port representations.
 >

I think you may be looking at some specific board design which has those
two NICs; there are typically many variations of such boards and they
have to be each dealt with slightly differently by whoever is porting. 
Important detail is:
we  already know how to deal with NICs - remove them from the diagram
and then the discussion is about the switch chip. I am assuming
the MNGMT interface is where the control is going to be. i.e
I can send table updates there, control the different port
charasterstics etc.
So Neil's option #1 is to have a driver controlling that interface
(->priv).
There's probably some DMA engine's for the datapath for one or more
of the ports this driver exposes...
Replace PCIE with DSA, a simulation chip, whatever the gazillion
crazy interfaces the openwrt guys have to deal with and we have
ourselves a consistent interface.


> Btw note this model fits into existing DSA as well I believe. The actual DSA
> devices whould act as NIC0, NIC1 and what would be added is the switch
> representation (couple of more netdevices to represent actual HW ports and
> their master)
>

Refer to my comments above.


cheers,
jamal