Re: [PATCH wpan-next] ieee802154: mrf24j40: support for external rx/tx

[Simon Vincent <simon.vincent@xsilon.com>]

I was under the impression the patch had been signed off. Maybe I missed 
a mail...
I can confirm the mrf24j40 works just fine using a DT.

Simon

On 23/09/14 08:19, Alexander Aring wrote:
> Hi,
>
> On Mon, Sep 22, 2014 at 11:51:43PM -0400, Alan Ott wrote:
>> On 09/16/2014 04:20 PM, Alexander Aring wrote:
>>> Hi Walter,
>>>
>>> On Tue, Sep 16, 2014 at 01:13:12PM -0700, Walter Mack wrote:
>>>> Alex,
>>>>
>>>> this is not a question of chip revisions. Chips with the same revision can
>>>> be used in designs with or without the external transmitter/receiver. Its
>>>> just that the chip has to be set up to be compatible with the design.
>>>>
>>> ah, ok. Dunno, I will wait on alan's opinion. If I don't heard anything in one
>>> week I will apply it.
>> Did Simon's patch get applied? I couldn't see it in any of the obvious
>> places when I looked the other day.
>>
> no, I finally wait for your Acked-by: .... otherwise I will not apply.
> That's indicate for me that this patch is okay for you and came into
> mainline. There are also pending patches from Varka, if you don't reply
> on it, I will not apply it. Should I always simple apply the patches
> if you don't response? It's better for me that I see a "Acked-by" from you.
>
> Simon's patch state:
> You had some reviewing notes at Simon's patch. I think Simon doesn't
> response to this yet. I didn't see any new versions of this.
>
>
>
> For DT example you can take a look into at86rf230 driver or cc2520. I
> mean examples to add some DT properties. Also if you want to make this
> driver dt enabled then you need a documentation in:
>
> Documentation/devicetree/bindings/net/ieee802154/$DRIVERNAME.txt
>
>
> - Alex