[PATCH v2 2/4] irqchip: bcm2835: If a parent interrupt is registered, chain from it.

[swarren@wwwdotorg.org (Stephen Warren)]

On 07/13/2015 07:35 PM, Eric Anholt wrote:
> The BCM2836 (Raspberry Pi 2) uses two levels of interrupt handling
> with the CPU-local interrupts being the root, so we need to register
> ours as chained off of the CPU's local interrupt.

Sorry for the slow review; laziness after vacation!

> diff --git a/Documentation/devicetree/bindings/interrupt-controller/brcm,bcm2835-armctrl-ic.txt b/Documentation/devicetree/bindings/interrupt-controller/brcm,bcm2835-armctrl-ic.txt

> +The BCM2836 contains the same interrupt controller with the same
> +interrupts, but the per-CPU interrupt controller is the root, and an
> +interrupt there indicates that the ARMCTRL has an interrupt to handle.
> +
>  Required properties:
>  
>  - compatible : should be "brcm,bcm2835-armctrl-ic"

Since there are some differences between the bcm2835 and bcm2836 HW
blocks, I'd expect the compatible value to be different for each. In
particular...

> +Optional properties:
> +- interrupt-parent : Specifies the parent interrupt controller when this
> +  controller is the second level.
> +- interrupts : Specifies the interrupt on the parent for this interrupt
> +  controller to handle.

I'd classify that as "additional required properties for
brcm,bcm2836-armctrl-ic"

... and with different compatible values for the two chips, you would
know when probe() should require vs. reject the property.