[PATCH v7 1/2] usb: make xhci platform driver use 64 bit or 32 bit DMA

[mathias.nyman@linux.intel.com (Mathias Nyman)]

On 31.08.2015 21:58, Duc Dang wrote:
> On Thu, Aug 20, 2015 at 12:38 PM, Duc Dang <dhdang@apm.com> wrote:
>> The xhci platform driver needs to work on systems that
>> either only support 64-bit DMA or only support 32-bit DMA.
>> Attempt to set a coherent dma mask for 64-bit DMA, and
>> attempt again with 32-bit DMA if that fails.
>>
>> [dhdang: regenerate the patch over 4.2-rc5 and address new comments]
>> Signed-off-by: Mark Langsdorf <mlangsdo@redhat.com>
>> Tested-by: Mark Salter <msalter@redhat.com>
>> Signed-off-by: Duc Dang <dhdang@apm.com>
>>
>> ---
>> Changes from v6:
>>          -Add WARN_ON if dma_mask is NULL
>>          -Use dma_coerce_mask_and_coherent to assign
>>          dma_mask and coherent_dma_mask
>>
>> Changes from v5:
>>          -Change comment
>>          -Assign dma_mask to coherent_dma_mask if dma_mask is NULL
>>          to make sure dma_set_mask_and_coherent does not fail prematurely.
>>
>> Changes from v4:
>>          -None
>>
>> Changes from v3:
>>          -Re-generate the patch over 4.2-rc5
>>          -No code change.
>>
>> Changes from v2:
>>          -None
>>
>> Changes from v1:
>>          -Consolidated to use dma_set_mask_and_coherent
>>          -Got rid of the check against sizeof(dma_addr_t)
>>
>>   drivers/usb/host/xhci-plat.c | 21 +++++++++++++--------
>>   1 file changed, 13 insertions(+), 8 deletions(-)
>>
>> diff --git a/drivers/usb/host/xhci-plat.c b/drivers/usb/host/xhci-plat.c
>> index 890ad9d..e4c7f9d 100644
>> --- a/drivers/usb/host/xhci-plat.c
>> +++ b/drivers/usb/host/xhci-plat.c
>> @@ -93,14 +93,19 @@ static int xhci_plat_probe(struct platform_device *pdev)
>>          if (irq < 0)
>>                  return -ENODEV;
>>
>> -       /* Initialize dma_mask and coherent_dma_mask to 32-bits */
>> -       ret = dma_set_coherent_mask(&pdev->dev, DMA_BIT_MASK(32));
>> -       if (ret)
>> -               return ret;
>> -       if (!pdev->dev.dma_mask)
>> -               pdev->dev.dma_mask = &pdev->dev.coherent_dma_mask;
>> -       else
>> -               dma_set_mask(&pdev->dev, DMA_BIT_MASK(32));
>> +       /* Throw a waring if broken platform code didn't initialize dma_mask */
>> +       WARN_ON(!pdev->dev.dma_mask);
>> +       /*
>> +        * Try setting dma_mask and coherent_dma_mask to 64 bits,
>> +        * then try 32 bits
>> +        */
>> +       ret = dma_coerce_mask_and_coherent(&pdev->dev, DMA_BIT_MASK(64));
>> +       if (ret) {
>> +               ret = dma_coerce_mask_and_coherent(&pdev->dev,
>> +                                                  DMA_BIT_MASK(32));
>> +               if (ret)
>> +                       return ret;
>> +       }
>>
>>          hcd = usb_create_hcd(driver, &pdev->dev, dev_name(&pdev->dev));
>>          if (!hcd)
>> --
>> 1.9.1
>>
>
> Hi Greg, Arnd, Russell,
>
> Do you have any more comment about this patch set?
>

I'm not sure I fully understand why we need to try the 64 bit DMA mask in platform probe.

As I understood it we just want to have some DMA mask set before calling usb_create_hcd()
to make sure USB core gets the "uses_dma" flag set and dma_set_mask() won't fail because of
missing dev->dma_mask.

The correct DMA mask is set later in xhci_gen_setup()

We also need to make sure the controller supports 64bit addressing capability before setting a 64 bit DMA mask.
(bit 0 in HCCPARAMS)

So for platform devices it goes look go this:

xhci_plat_probe()
   usb_create_hcd()
     usb_create_shared_hcd()
       hcd->self.uses_dma = (dev->dma_mask != NULL);
   usb_add_hcd()
     hcd->driver->reset()  (.reset = xhci_plat_setup)
       xhci_plat_setup()
         xhci_gen_setup()
           if (HCC_64BIT_ADDR(xhci->hcc_params) && !dma_set_mask(dev, DMA_BIT_MASK(64))) {
             xhci_dbg(xhci, "Enabling 64-bit DMA addresses.\n");
             dma_set_coherent_mask(dev, DMA_BIT_MASK(64));
           }

or do we end up with dev->dma_mask = NULL on 64-bit DMA only after trying to set it to 32 in xhci_plat_probe(),
and thus also failing the dma_set_mask() in xhci_gen_setup()?

-Mathias