Re: [PATCH v2] spi: Setup the master controller driver before setting the chipselect

["Franklin S Cooper Jr." <fcooper-l0cyMroinI0@public.gmane.org>]

On 10/16/2015 10:45 AM, Andy Shevchenko wrote:
> On Fri, Oct 16, 2015 at 6:29 PM, Franklin S Cooper Jr <fcooper-l0cyMroinI0@public.gmane.org> wrote:
>> SPI controllers may need to be properly setup before chip selects
>> can be used. Therefore, wait until the spi controller has a chance
>> to perform their setup procedure before trying to use the chip
>> select.
>>
>> This also insures that the chip selects pins are in a good
>> state before asseting them which otherwise may cause confusion.
>>
>> Signed-off-by: Franklin S Cooper Jr <fcooper-l0cyMroinI0@public.gmane.org>
> Does it mean I have to test it again?
Oops sorry. No the patch hasn't changed. I can shoot a v3 with your tested by included.
>
>> ---
>> Keystone 2 devices currently fail to boot in linux-next after the
>> below commit was applied:
>>
>> spi: bitbang: switch to the generic implementation of transfer_one_message
>> commit: 0037686596832572bbca05ab168d9884d7d704c1
>>
>> This patch allows Keystone 2 devices to boot again in linux-next.
>>
>> Tested this patch on K2E evm and am437 starterkit which both have SPI
>> devices to insure regressions aren't seen.
>>
>> V2 Changes:
>> Update commit message.
>>
>>  drivers/spi/spi.c | 4 ++--
>>  1 file changed, 2 insertions(+), 2 deletions(-)
>>
>> diff --git a/drivers/spi/spi.c b/drivers/spi/spi.c
>> index 4c638f3..9d5525a 100644
>> --- a/drivers/spi/spi.c
>> +++ b/drivers/spi/spi.c
>> @@ -2059,11 +2059,11 @@ int spi_setup(struct spi_device *spi)
>>         if (!spi->max_speed_hz)
>>                 spi->max_speed_hz = spi->master->max_speed_hz;
>>
>> -       spi_set_cs(spi, false);
>> -
>>         if (spi->master->setup)
>>                 status = spi->master->setup(spi);
>>
>> +       spi_set_cs(spi, false);
>> +
>>         dev_dbg(&spi->dev, "setup mode %d, %s%s%s%s%u bits/w, %u Hz max --> %d\n",
>>                         (int) (spi->mode & (SPI_CPOL | SPI_CPHA)),
>>                         (spi->mode & SPI_CS_HIGH) ? "cs_high, " : "",
>> --
>> 2.6.1
>>
>
>

--
To unsubscribe from this list: send the line "unsubscribe linux-spi" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html