Re: [PATCH V8 1/2] mtd: spi-nor: Bindings for Cadence Quad SPI Flash Controller driver.

[Vignesh R <vigneshr@ti.com>]

On 02/06/2016 01:12 PM, Marek Vasut wrote:
> On Thursday, February 04, 2016 at 06:30:27 PM, R, Vignesh wrote:
>> On 2/4/2016 4:55 PM, Marek Vasut wrote:

[...]

>> Yeah, there is delay(of few ns) required between writing to
>> INDIRECTWR_START bit and actually writing data to flash(i.e writesl()
>> call). This is specific to TI K2G SoC and needs to be tied to the new
>> binding.
> 
> Can't you somehow poll the hardware to check whether or not it's ready instead
> of adding some random delay ?

There is no dedicated register to poll as such.

According to TRM:
"Wait for couple of cycles of QSPI_REF_CLK(functional clock of QSPI
@384MHz) until CQSPI_REG_INDIRECTWR[0] bit is internally synchronized by
the QSPI module before writing to flash".

So, a few ns(~6ns @384MHz) delay is needed (or accessing a QSPI module
register should be sufficient as it will take more than 2 clock cycles).
I believe this delay is specific to TI K2G SoC and maybe needs to be
tied to the binding.


-- 
Regards
Vignesh