Re: PM branch updated to v2.6.35, SRF dropped

[Kevin Hilman <khilman@deeprootsystems.com>]

Nishanth Menon <nm@ti.com> writes:

> Kevin Hilman had written, on 08/04/2010 05:50 PM, the following:
> [...]
>
>> I've only tested the new PM branch on a couple boards to avoid any
>> further delay getting this version out, update, so hopefully others will
>> help test.
>>
>> I've tested RET on idle & suspend, OFF in idle & suspend on:
>>
>> 3430/omap3evm: works
>>
>> 3630/Zoom3: works
>> - Known problem: console hangs on UART wakeup when  wakeups are enabled using
>>   echo enabled > /sys/devices/platform/serial8250.0/tty/ttyS0/power/wakeup
>>   but I haven't debugged this further.
>
> Just sharing results from SDP testing omap3_pm_defconfig + earlyprintk:
> SDP3430 (with denx.com u-boot, nor boot): does not boot to shell
> full Bootlog: http://pastebin.mozilla.org/761964

Does the same setup boot fine on l-o for-next, or l-o master? 

> SDP3630 (with TI u-boot, xloader, mmc boot): ret works, uart wakeup
> fails for off mode (I am guessing this is similar to Kevin's results)
> full Bootlog: http://pastebin.mozilla.org/761966

> OMAP4 Blaze (with TI u-boot, xloader, mmc boot): does not boot, hell
> lot of crashes - note, need to explicitly enable MACH_OMAP4430_SDP in
> .config
> full Bootlog: http://pastebin.mozilla.org/761968

yeah, I don't expect PM branch to work on OMAP4 until we get the OMAP4 hwmod
core upstream.

Kevin