Re: PM branch updated to v2.6.35, SRF dropped

[Nishanth Menon <nm@ti.com>]

Kevin Hilman had written, on 08/04/2010 05:50 PM, the following:
[...]

> I've only tested the new PM branch on a couple boards to avoid any
> further delay getting this version out, update, so hopefully others will
> help test.
> 
> I've tested RET on idle & suspend, OFF in idle & suspend on:
> 
> 3430/omap3evm: works
> 
> 3630/Zoom3: works
> - Known problem: console hangs on UART wakeup when  wakeups are enabled using
>   echo enabled > /sys/devices/platform/serial8250.0/tty/ttyS0/power/wakeup
>   but I haven't debugged this further.

Just sharing results from SDP testing omap3_pm_defconfig + earlyprintk:
SDP3430 (with denx.com u-boot, nor boot): does not boot to shell
full Bootlog: http://pastebin.mozilla.org/761964

SDP3630 (with TI u-boot, xloader, mmc boot): ret works, uart wakeup 
fails for off mode (I am guessing this is similar to Kevin's results)
full Bootlog: http://pastebin.mozilla.org/761966

OMAP4 Blaze (with TI u-boot, xloader, mmc boot): does not boot, hell lot 
of crashes - note, need to explicitly enable MACH_OMAP4430_SDP in .config
full Bootlog: http://pastebin.mozilla.org/761968

[...]

-- 
Regards,
Nishanth Menon