[PATCH v4 3/3] ARM: mvebu: Add the hardware monitor to the NSA320 device tree

[gregory.clement@free-electrons.com (Gregory CLEMENT)]

Hi Adam,
 
 On sam., mars 05 2016, Adam Baker <linux@baker-net.org.uk> wrote:

> Add an entry for the hardware monitoring MCU
>
> Signed-off-by: Adam Baker <linux@baker-net.org.uk>

Applied on mvebu/dt, I only changed the tropic to "ARM: dts: kirkwood:
Add the hardware monitor to the NSA320 device tree" as know requested
by the arm-soc maintainer.

Thanks,

Gregory

> ---
> This patch is unchanged from the version Gregory CLEMENT said
> he would apply once the hwmon maintainers accept 2/3
> ---
>  arch/arm/boot/dts/kirkwood-nsa320.dts | 13 +++++++++++--
>  1 file changed, 11 insertions(+), 2 deletions(-)
>
> diff --git a/arch/arm/boot/dts/kirkwood-nsa320.dts b/arch/arm/boot/dts/kirkwood-nsa320.dts
> index 24f686d..2a935e9 100644
> --- a/arch/arm/boot/dts/kirkwood-nsa320.dts
> +++ b/arch/arm/boot/dts/kirkwood-nsa320.dts
> @@ -193,10 +193,19 @@
>  		};
>  	};
>  
> +	hwmon {
> +		compatible = "zyxel,nsa320-mcu";
> +		pinctrl-0 = <&pmx_mcu_data &pmx_mcu_clk &pmx_mcu_act>;
> +		pinctrl-names = "default";
> +
> +		data-gpios = <&gpio0 14 GPIO_ACTIVE_HIGH>;
> +		clk-gpios = <&gpio0 16 GPIO_ACTIVE_HIGH>;
> +		act-gpios = <&gpio0 17 GPIO_ACTIVE_LOW>;
> +	};
> +
>  	/* The following pins are currently not assigned to a driver,
>  	   some of them should be configured as inputs.
> -	pinctrl-0 = <&pmx_mcu_data &pmx_mcu_clk &pmx_mcu_act
> -		     &pmx_htp &pmx_vid_b1
> +	pinctrl-0 = <&pmx_htp &pmx_vid_b1
>  		     &pmx_power_resume_data &pmx_power_resume_clk>; */
>  };
>  
> -- 
> 2.1.4
>

-- 
Gregory Clement, Free Electrons
Kernel, drivers, real-time and embedded Linux
development, consulting, training and support.
http://free-electrons.com