Re: [PATCH v2 1/3] dt-bindings: i3c: xlnx: Add IBI and hot-join capability properties

[Frank Li <Frank.li@oss.nxp.com>]

On Mon, Aug 24, 2026 at 10:18:33AM +0530, Shubham Patil wrote:
> In-Band Interrupt and Hot-Join are synthesis-time options of the AXI I3C
> IP. Describe them with two boolean properties.
>
> A Hot-Join request is acknowledged by the IBI machinery, so a hot-join
> capable design is always IBI capable as well. Both events are reported
> through the controller interrupt, which is therefore required whenever
> the capability is present.
>
> Signed-off-by: Shubham Patil <shubhamsanjay.patil@amd.com>
> ---
> Changes in V2:
> - Rename the properties to "xlnx,in-band-interrupt-capable" and
>   "xlnx,hot-join-capable", and expand their descriptions.
> - Express the interrupt requirement with dependencies: instead of an
>   allOf/if-then clause.
> ---
>  .../bindings/i3c/xlnx,axi-i3c-1.0.yaml        | 24 +++++++++++++++++++
>  1 file changed, 24 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/i3c/xlnx,axi-i3c-1.0.yaml b/Documentation/devicetree/bindings/i3c/xlnx,axi-i3c-1.0.yaml
> index 2caa245a8656..a04becc07374 100644
> --- a/Documentation/devicetree/bindings/i3c/xlnx,axi-i3c-1.0.yaml
> +++ b/Documentation/devicetree/bindings/i3c/xlnx,axi-i3c-1.0.yaml
> @@ -32,11 +32,33 @@ properties:
>    interrupts:
>      maxItems: 1
>
> +  xlnx,in-band-interrupt-capable:
> +    type: boolean
> +    description:
> +      The IP is synthesized with In-Band Interrupt support. An In-Band
> +      Interrupt lets a target signal the controller over the SDA and SCL
> +      pair instead of a dedicated side-band interrupt line, by driving its
> +      own dynamic address during bus arbitration. Such requests are
> +      reported through the controller interrupt.
> +
> +  xlnx,hot-join-capable:
> +    type: boolean
> +    description:
> +      The IP is synthesized with Hot-Join support. Hot-Join lets a target
> +      attached or powered up after the bus is already running announce
> +      itself using the reserved Hot-Join address, so that the controller
> +      can assign it a dynamic address. The request is acknowledged by the
> +      same machinery as an In-Band Interrupt.
> +

I perfer put both to i3c.yaml

Frank

>  required:
>    - compatible
>    - reg
>    - clocks
>
> +dependencies:
> +  xlnx,hot-join-capable: ["xlnx,in-band-interrupt-capable"]
> +  xlnx,in-band-interrupt-capable: [interrupts]
> +
>  allOf:
>    - $ref: i3c.yaml#
>
> @@ -54,5 +76,7 @@ examples:
>          interrupts = <GIC_SPI 89 IRQ_TYPE_LEVEL_HIGH>;
>          #address-cells = <3>;
>          #size-cells = <0>;
> +        xlnx,in-band-interrupt-capable;
> +        xlnx,hot-join-capable;
>      };
>  ...
> --
> 2.34.1
>