From: "Philippe Mathieu-Daudé" <philmd@oss.qualcomm.com>
To: qemu-devel@nongnu.org
Cc: Helge Deller <deller@gmx.de>,
Richard Henderson <richard.henderson@linaro.org>,
Paolo Bonzini <pbonzini@redhat.com>,
Mark Cave-Ayland <mark.cave-ayland@ilande.co.uk>,
Fam Zheng <fam@euphon.net>, Keith Monahan <keith@techtravels.org>,
BALATON Zoltan <balaton@eik.bme.hu>
Subject: Re: [RFC PATCH-for-11.2 v4 00/14] nc53c710 rewrite
Date: Fri, 20 Nov 2026 18:20:27 +0100 [thread overview]
Message-ID: <dfbbba97-a182-4f5e-acd1-c962285ff463@oss.qualcomm.com> (raw)
In-Reply-To: <20261120171235.61325-1-philmd@oss.qualcomm.com>
On 20/11/26 18:12, Philippe Mathieu-Daudé wrote:
> Fourth attempt to replace the existing 53c710 driver by
> a new driver based on the code of the lsi53c895a.c :)
>
> Used LLM to decompose v3 as logical / atomic changes when
> possible (didn't work well with the rewrite patch).
>
> Fixes extracted first so could be merged for v11.2 (patches
> 1 to 5). The rest is the rewrite, so up to the maintainers
> (Helge, Mark) and is probably OK as hobbyist-only code.
>
> Since v3:
> - header split, Suggested-by tag (Zoltan)
> - I couldn't figure the "hw/misc/lasi.c" change so dropped
> the comment about it.
> - Dropped "move to COMMAND on CLEAR ACK after MESSAGE REJECT"
> - Split rewrite patch as separated commits:
> - base engine
> - asynchronous completions
> - synchronous drain
> - HP-UX MESSAGE REJECT quirk
> - reentrancy guard and reset-time request cancel
>
> hw/scsi/ncr53c710.c is derived from hw/scsi/lsi53c895a.c which
> is LGPL, the rewrite is now declared GPL-2.0-or-later.
> hw/scsi/lsi_scsi.h, which is moved verbatim from lsi53c895a.c,
> keeps the original terms: its header says "This code is licensed
> under the LGPL." with SPDX-License-Identifier: LGPL-2.1-or-later.
>
> Series reviewed against the NCR 53C710 data manual but totally
> untested (I don't have guest code to run), thus compile-checked
> only. I haven't tested whether the series is bisectable.
This is only a split experiment if Helge/Keith/Mark/Zoltan want
to pursue, I'm not going to respin.
> Keith Monahan (9):
> hw/scsi/scsi-disk: Add quirk_mode_page_no_flexible_disk, use it on the
> 715
> hw/scsi: Move shared LSI/NCR definitions to lsi_scsi.h
> hw/scsi/ncr53c710: Rewrite the 53C710 SCRIPTS engine
> hw/scsi/ncr53c710: Deliver completions from bottom halves
> hw/scsi/ncr53c710: Drain asynchronous transfers in the register write
> hw/scsi/ncr53c710: Append SAVE DATA POINTERS after MESSAGE REJECT for
> HP-UX
> hw/scsi/ncr53c710: Guard SCRIPTS reentrancy and cancel requests on
> soft reset
> hw/scsi/lasi_ncr710: Map the full LASI SCSI module page
> hw/scsi/ncr53c710: Bump the migration version
>
> Philippe Mathieu-Daudé (5):
Oops here author should be Keith Monahan?
> hw/scsi/ncr53c710: Cancel the in-flight request on soft reset
> hw/scsi/ncr53c710: Do not load SBCL from DBC after a SCRIPTS phase
> move
> hw/scsi/lasi_ncr710: Limit max_target and max_lun to 7
> hw/scsi/ncr53c710: Keep DCNTL.EA and DMODE.FC1 across an ISTAT.RST
> reset
> hw/scsi/ncr53c710: Document the SIGP latch deviation
next prev parent reply other threads:[~2026-11-20 17:20 UTC|newest]
Thread overview: 22+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-11-20 17:12 [RFC PATCH-for-11.2 v4 00/14] nc53c710 rewrite Philippe Mathieu-Daudé
2026-11-20 17:12 ` [RFC PATCH-for-11.2 v4 01/14] hw/scsi/ncr53c710: Cancel the in-flight request on soft reset Philippe Mathieu-Daudé
2026-11-20 17:12 ` [RFC PATCH-for-11.2 v4 02/14] hw/scsi/ncr53c710: Do not load SBCL from DBC after a SCRIPTS phase move Philippe Mathieu-Daudé
2026-11-20 17:12 ` [RFC PATCH-for-11.2 v4 03/14] hw/scsi/scsi-disk: Add quirk_mode_page_no_flexible_disk, use it on the 715 Philippe Mathieu-Daudé
2026-11-20 17:12 ` [RFC PATCH-for-11.2 v4 04/14] hw/scsi/lasi_ncr710: Limit max_target and max_lun to 7 Philippe Mathieu-Daudé
2026-11-20 17:12 ` [RFC PATCH-for-11.2 v4 05/14] hw/scsi/ncr53c710: Keep DCNTL.EA and DMODE.FC1 across an ISTAT.RST reset Philippe Mathieu-Daudé
2026-11-20 17:12 ` [RFC PATCH-for-11.2? v4 06/14] hw/scsi: Move shared LSI/NCR definitions to lsi_scsi.h Philippe Mathieu-Daudé
2026-11-20 22:10 ` BALATON Zoltan
2026-11-20 17:12 ` [RFC PATCH-for-11.2??? v4 07/14] hw/scsi/ncr53c710: Rewrite the 53C710 SCRIPTS engine Philippe Mathieu-Daudé
2026-11-20 22:13 ` BALATON Zoltan
2026-11-20 17:12 ` [RFC PATCH-for-11.2? v4 08/14] hw/scsi/ncr53c710: Deliver completions from bottom halves Philippe Mathieu-Daudé
2026-11-20 17:12 ` [RFC PATCH-for-11.2? v4 09/14] hw/scsi/ncr53c710: Drain asynchronous transfers in the register write Philippe Mathieu-Daudé
2026-11-20 17:12 ` [RFC PATCH-for-11.2? v4 10/14] hw/scsi/ncr53c710: Append SAVE DATA POINTERS after MESSAGE REJECT for HP-UX Philippe Mathieu-Daudé
2026-11-20 17:12 ` [RFC PATCH-for-11.2? v4 11/14] hw/scsi/ncr53c710: Guard SCRIPTS reentrancy and cancel requests on soft reset Philippe Mathieu-Daudé
2026-11-20 22:17 ` BALATON Zoltan
2026-11-20 17:12 ` [RFC PATCH-for-11.2? v4 12/14] hw/scsi/lasi_ncr710: Map the full LASI SCSI module page Philippe Mathieu-Daudé
2026-11-20 17:12 ` [RFC PATCH-for-11.2? v4 13/14] hw/scsi/ncr53c710: Document the SIGP latch deviation Philippe Mathieu-Daudé
2026-11-20 17:12 ` [RFC PATCH-for-11.2? v4 14/14] hw/scsi/ncr53c710: Bump the migration version Philippe Mathieu-Daudé
2026-11-20 22:21 ` BALATON Zoltan
2026-11-20 17:20 ` Philippe Mathieu-Daudé [this message]
2026-11-20 22:09 ` [RFC PATCH-for-11.2 v4 00/14] nc53c710 rewrite BALATON Zoltan
2026-11-20 23:14 ` Helge Deller
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=dfbbba97-a182-4f5e-acd1-c962285ff463@oss.qualcomm.com \
--to=philmd@oss.qualcomm.com \
--cc=balaton@eik.bme.hu \
--cc=deller@gmx.de \
--cc=fam@euphon.net \
--cc=keith@techtravels.org \
--cc=mark.cave-ayland@ilande.co.uk \
--cc=pbonzini@redhat.com \
--cc=qemu-devel@nongnu.org \
--cc=richard.henderson@linaro.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.