Re: [PATCH v3 11/12] dt-bindings: pci: rockchip,rk3399-pcie-ep: Add ep-gpios property

[Krzysztof Kozlowski <krzk@kernel.org>]

On 07/10/2024 08:58, Damien Le Moal wrote:
> On 10/7/24 15:54, Krzysztof Kozlowski wrote:
>> On 07/10/2024 08:50, Damien Le Moal wrote:
>>> On 10/7/24 15:12, Krzysztof Kozlowski wrote:
>>>> On Mon, Oct 07, 2024 at 01:12:17PM +0900, Damien Le Moal wrote:
>>>>> From: Wilfred Mallawa <wilfred.mallawa@wdc.com>
>>>>>
>>>>> Describe the `ep-gpios` property which is used to map the PERST# input
>>>>> signal for endpoint mode.
>>>>
>>>> Why "ep" for PERST signal? Looks totally unrelated name. There is
>>>> already reset-gpios exactly for PERST, so you are duplicating it. Why?
>>>
>>> Because the host side controller already has the same "ep-gpios" property.
>>>
>>> Documentation/devicetree/bindings/pci/rockchip,rk3399-pcie.yaml
>>
>> If host has it, then it is a common property so goes to common schema
>> for these devices.
> 
> Ah. OK. I will move it to
> Documentation/devicetree/bindings/pci/rockchip,rk3399-pcie-common.yaml then.
> 
>>> So naming that property the same allows common code to initialize that gpio in
>>> rockchip_pcie_parse_dt().
>>>
>>> Also, I do not see reset-gpios being defined/used by this driver (host and ep
>>> sides).
>>
>> I am talking about bindings, not driver.
> 
> I do not see reset-gpios being defined in the bindings (common, host and ep).
> resets and reset-names are defined though but these have nothing to do with
> #PERST control.

Bindings for all PCI devices. See pci-bus-common.yaml

Best regards,
Krzysztof